Search results

Hi, I am ready to add the pots to my Duocast PCB but I have some questions before I get started. Most important question--I'd like to test out the circuit before I wire the switches. That simplifies troubleshooting when something inevitably goes wrong. The problem is that I can't figure out...

I feel very stupid right now posting this, but I think it's time to get an outside perspective. I built the Son of Ben and it sounds spectacular. The problem is, when I boxed it and tightened up the nuts on the pots (not ridiculously tight, just a bit more than hand tightening) the sound and...

I'm not normally a bad builder but I went through a phase where I was doing my work late at night and probably exhausted from work. So I've had a pile of PCBs that don't quite work right. Current problem is the Fender Blender PCB. Info here: https://docs.pedalpcb.com/project/Blender.pdf I'll...

Hi, I build the Octagon MultiFX pedal :https://www.pedalpcb.com/product/octagon/ I was wondering if I could put in a custom programmed EEPROM into that pedal to change around some of the effects. Or does that only work with the Arachnid? Also, any thoughts on the various programmable effects...

Hello, I've been building pedals for a few years now but I am new to this forum. I built up the Leprechaun and ran it through my testing rig. Right now, I get only clean sound when the circuit is hooked up. Since the schematic isn't up yet, I'm stumped about how to troubleshoot this but I'm...