Search results

This seems to differ from other electric mistress schematics I’ve seen. That node is connected to the clock input of the CD4013. It may just be a test point for the VCO trim. Not entirely sure why that’s being brought out with the other supply pins. Do you have any other documentation? Is there...

Right—the main purpose of the net designation is to make the schematic less cluttered. The board will have to have physical connections.

Oh boy. You should contact their customer service.

There are two parallel RC networks forming a HPF with the ground connection of the feedback loop. The 47R / 2u2 network creates a 1.5kHz pole. You could modify that (similar the the Ruetz mod on the other pole), but you’ll affect the gain as well. There’s a LPF with the feedback cap and the GAIN...

This initial question was about a cheap bench amp, right?

Solid state?

Get the monoprice 5W. Lots of positive reception from folks on the board. I use one for exactly the purpose you’re describing.

Monoprice 5W or 15W.

Maybe explain how the circuit works. The only benefit to the blend I could see is bypassing the tone control.

That will always be funny.

Good to know. I’ll have to give that a shot.

Did that actually work with the reissue vactrol? This remains my sole abandoned project.

They followed the form, but didn't have the hinge/plate.

No reason not to. Just leave the third lug empty if all you’re trying to do is interrupt the supply.

My little pony?

The klon already blends the clean and gain signal paths. You want to blend more clean with the clean/gain blend?

Wow. I didn't realize this was an excuse request thread.

2N2221 and 2N3903 are good candidates. You may get devices that measure a bit higher than 60 though.

You could use the spdt switch to basically bypass the relay and use the spst footswitch itself for momentary. The intelligent relay would have the momentary feature if you were to hold the switch when the relay is in-circuit, so one of the basic relay boards that don’t have the momentary...

Did you build the library from scratch or modify existing footprints?