Search results

I haven't yet. Trying to hold off on any 'Bean orders until the 12 Stage and MicroSynth drop

That idea is pretty rad! Gonna have to research that ribbon controller a bit

Figured I may as well demo my surfiest little ditty (and some others) I really need to replace the spring tank in my amp

Here's a quickie, clean and with a Rat2 I'll try to get another when I can turn up a bit louder Sorry, @Feral Feline. No socks, but here's some not-Crocs -

Yeah, so far I'm not huge into the subdued attack of lower tuning and fatter strings. It sounds fine, but I prefer the stabby note onset. Here's my other Telemaster tuned to drop G -

Couple more snippets, this time with a SHO input. The 386 input is coming directly from the guitar. This brings it up to unity gain, and slightly louder with some dirt in the highest gain settings Pins lifted - Pins inserted -

Warmoth Jazzcaster body in gloss white pearl, and black matte pickguard. Alder DC Kunkle 30.25" conversion neck. Maple Seymour Duncan Vintage Broadcaster STL-1b pickup, wired straight to the output jack. Magnets & wire Black Tusq nut Hipshot Open gear locking staggered tuning machines Musiclily...

@Manischewitz_Papi reached out for guidance on this, so I slapped this together and made a couple little snippets of a clean Chalumeau. Using the JFET buffer, as the next cleanest preamp board I have on hand is the OD-1. Input goes to the buffer which has it's output split - one side going...

I never did get to a demo of that unit 😅 It was cool, but the expression input was way too finicky for me. I've got another board on hand that I wanna try some other stuff at point Another rad one, that doesn't get mentioned a lot is the Anderton Super Tone Control / Pro-Filter Here's my...

Another installment of my expanded EHX thing I'm on this week. This time the Clone Theory, courtesy of the LectricFX Celeste board. I'd actually intended to do the Old Chap today, but I'm out of the necessary 1/8w resistors, so here's this Mods are as follows- R17 swapped for a 100kA pot and...

One for the LFO, one for manual mode

Beyond moving the toggles (and a couple pots) to footswitches, these are built according to the docs. Though I'm pretty sure I did something to the PolyTrog to slow it down in LFO mode, I can't recall what it was 🤷‍♂️ Think I've got the PolyTrog's envelope bias set to 6.6v. The Bloodstone...

These turned out absolutely gorgeous!

Correct. It sets the gain of the summing / output stage. Probably wouldn't hurt to make it a pot, even

Yep, it was too quiet stock, so I adjusted R12 until I was happy. The trimpot effects the input gain, not the output The pots aren't backward, but yes- I've got the center lugs soldered to the board, and wires from the other lugs to their respective holes

I actually found my notes! Transistor readings are from a TC1-alike, diode readings from my DMM Edit - the transistor swapper board Moonn Electronics

I hear rumours that @bean might be dropping a 12 stage soon. Not sure how similar it'll be to this one, but I believe it's also an OTA phaseyboi

The particular Staz-On pad I use doesn't have raised edges, but I haven't tried any particularly large stamps

Yep! I had one of my spasms when laying down the "fright" so I decided to leave it and lean into it

I had to reflow mine a couple times. It seemed to want to have it's legs shorted together