Search results

  1. C

    SOLVED Abyss rate led stuck on

    So they are not close at all. Top was at 219k and bottom was 67k
  2. C

    SOLVED Abyss rate led stuck on

    @Chuck D. Bones or @zgrav any ideas? I can send more pictures if you need
  3. C

    SOLVED Abyss rate led stuck on

    Updated, swapped out C11-c13 with tant caps, and resoldered the rate pot. LED would pulse for about 2 seconds and then it stayed lit the whole time. Everything looks clean and no debris/cold joints to my knowledge
  4. C

    SOLVED Abyss rate led stuck on

    Going to redo the rate pot today and clean up any solder under that pot. Hopefully that solves it. If not I'll try the new caps next!
  5. C

    SOLVED Abyss rate led stuck on

    Looks like q1c voltage did not change when the speed pot was adjusted. Still around that 2.13 V range
  6. C

    SOLVED Abyss rate led stuck on

    So on the schematic, I traced out everything connected to q1, aka that whole bottom section. Everything looked good and continuity was where it should be
  7. C

    SOLVED Abyss rate led stuck on

    I have continuity between the middle lug and right lug on the dual pot so I bet that's the issue (middle and the lug that is connected to the square pad) EDIT I see that is correct on the schematic
  8. C

    SOLVED Abyss rate led stuck on

    I have not removed any parts, I did 2 reflows so maybe a piece so solder got stuck somewhere. I'll check the rate pot and those resistors and caps!
  9. C

    SOLVED Abyss rate led stuck on

    2.166V DC measured from Q1-C to the ground lug on the DC socket
  10. C

    SOLVED Abyss rate led stuck on

    Alright, guys thanks for the help! I ordered some 1uF tant caps and will double-check the rate pot for cold joints and also no shorts on the footswitch wires. I'll get the caps replaced and report back after that
  11. C

    SOLVED Abyss rate led stuck on

    Yeah it's the led in the ldr group. I'll have to see if I have any tantalum around
  12. C

    SOLVED Abyss rate led stuck on

    Here's those!
  13. C

    SOLVED Abyss rate led stuck on

    I tested both in and out of the enclosure and it still doesn't change
  14. C

    SOLVED Abyss rate led stuck on

    Here are some photos of the underside
  15. C

    SOLVED Abyss rate led stuck on

    The rate function did work but now turning that knob does not do anything
  16. C

    SOLVED Abyss rate led stuck on

    I'll upload some pictures
  17. C

    SOLVED Abyss rate led stuck on

    The level definitely works and so does the knob to turn the brightness of the led, I think that's the intensity
  18. C

    SOLVED Abyss rate led stuck on

    Hello everyone, Just finished wiring up my abyss pedal. Sounded great and then I noticed the rate led stopped pulsing and is now stuck always lit up. I reflowed as many solder joints as I could and cleaned the board up too. Any ideas?
  19. C

    Dumbloid Twin build

    That's the one! Thanks
  20. C

    Dumbloid Twin build

    That's what I'm hoping to do, have each channel run vertically then the 2 foot switches
Back
Top