Search results

You are right https://forum.pedalpcb.com/threads/c2c-electronics-summer-break.22568/#post-295930

GO FOR IT I just removed it from my cart, unfortunatelly it is not worth it to import...

This is goind to be an expensive pcb even with jlcpcb.

Are the weird resistor values from dead end fx based on the actuall values the dmm showed while tracing (including the tolerance) or are the makers of the circuits (noticed that for spaceman fx) able to hear a pin drop?

I love it exactly for the nice controls as you describe it. And I also want build the Sea Horse!

MXR M 234

Learned: flat side of the printed led is the cathode.

The original is translated to contraption but this can't be found on the emma website https://www.premierguitar.com/gear/emma-electronic-py-1-pisdiyauwot-metal-distortion-pedal-review

Until now I thought that a square pad means - (cathode, negative, ground etc) but I was wrong. The led was soldered the other way around. Of course should the led light up as in every other pedal!!!!! Min Max And the clipping is not subtle. The subtleness vanishes after the pot is at noon...

I don’t need numbers i just import the template :ROFLMAO:

sir this is a diy forum! the answer is clear :ROFLMAO: Edit: another slo choice if it has to be a preamp https://www.musikding.de/High-Gain-Tube-Preamp-Kit

The resistors all have the correct value. Volume and tone at noon, gain max, clip min. Yellow Ch1 is on clip pin3, blue Ch2 is on pin1. When I turn the pot on max both are of course equal (no screenshot...). C15&R13 Other voltage scale than above but you can see the difference in waveform

Yes the other controls are fine. Yes it clips. I will cut lug 3 and see what happens. Maybe add a switch as mentioned in the build document and throw other diods in there. From AMZ: So my ears are not suitable for subtle :-)

It seems to be doing something. On the oscilloscope I can see a very slight shift on the y axis towards the positive with only a few millivolts at the end of the pot turn.

Hi everyone, I finished a GCI Gorilla Glasses and it seems to have no audible effect to turn the Clip pot. I can't hear any difference. On an oscilloscope it make more difference to cough at the gain pot than to turn the clip pot. The pot is fine and changing resistance up to 5k. The dmm shows...

doh… it was renamed from „calamity“. now I found the threads:-)

Thanks! They came in a kit, I will forward this information to Musikding :-)

Hello fellow flux fume sniffers, is there a rule on when it's ok to use J113 instead of J201? I did build a few Pedals where I substituted the J113 and they were fine. The Desolate Fuzz does not work with them. I measured both J113. VG off -1,87V at ID 5uA VG on -1,01V at ID 5mA gfs 10,4mA/V...

Thank you!

If this thread is dead I will hijack it :-) I have an issue between Q1 and Q2 but I will figure it out. C3 and C4 are should be the only differents bewteen current pcb and the layout in the build document. @Robert is this correct?