Search results

I'm not sure what you mean. The EHX Triangle versions listed on the Kit Rae site are all 100R, 120R, or 150R. The other BOMs have their Triangle versions as 820R. The next resistor over (kitrae R23) is usually 820R, so it is probably just an error. There are probably untold numbers of builds and...

I think dual mono is separate controls for each channel and stereo is the same controls for both channels. Either way, there are 2 in and 2 outs. If you combine the analog processing, it becomes pseudo-stereo rather than true stereo.

True stereo essentially means you duplicate all the circuitry so you could put two of the same pcbs in one box

It would have made a lot more sense to do caps in parallel and resistors in series and have the switch bypass one of the resistors.

I've just realized that you can't do an EHX version with all up or down dip switches. Bummer.

I think they are coming out with a guitar pedal focused submodule soon that is supposed to solve the issue.

There are 4 pedals built on that same board. FX50-B Overdrive Plus FX52 Classic Fuzz FX53 Classic Tube FX55-B Supra Distortion I did a post about it here: https://www.madbeanpedals.com/forum/index.php?topic=32722.msg314576#msg314576

I'm curious, was that specifically with a Onespot daisy chain?

Without knowing any requirements, the Onespot is definitely the starting point. It's specifically designed for pedals by R G Keen and it's very quiet. If you need 18v get the voltage doubler add-on. If you really need true isolation for some reason, then that's a requirement that it doesn't...

Do you know what pedals you'll have on it? Anything digital or that requires more than 9v?

https://www.mouser.com/ProductDetail/Bourns/TC42X-2-104E?qs=QYa8ZXxbnEbE7GBci46ntg%3D%3D I'm scared of how small these are

Are there any top adjust trim pots that fit in the space of a resistor without overhang? The narrowest I can find are mostly about 4mm wide. A 1/4W resistor is about 2.5mm. The narrowest I can find is the Bourns 3290W at 3.81mm

I remember looking into Retrovalves as well back during the tube shortage but I could never find anything about the construction. They had ready stopped making them so I guess they didn't sell well back when tubes were available and cheaper. https://jetcitycustom.com/pedals-and-retrovalves/

I looked into this a while back. It thought it seemed a bit more complicated. I'll have to revisit. https://amtelectronics.com/new/amt-12ax7ws-le/

A couple of questions... 1) Depending on what schematic you look at, sometimes the clipping cap and diodes are reversed. For instance, the Kit Rae and Muffin Factory schematics are one way and the Muffin Fuzz and Mudbunny are the other way. Does it matter? 2) The Kit Rae diagram below shows...

So a lizard queen then? :D

Sounds pretty good to me. I'm working on one right now. Any values you would change from stock?

I've circled back around to this and was looking to use the Triangle version as my baseline for my build. After looking thru the Triangle value list in the Juansolo, Muffin Fuzz, and Mudbunny documents, I think the 820R value listed for R5 in all of them is a mistake. It should be 100R. It is...

I've used transparency sheets on an inkjet printer. Print in reverse for ink side down and xacto knife to cut out the holes. You can even spray paint the back. The background colors on this one are from the inkjet printer The orange and sparkle background is spray paint on this one

Do you have an effect loaded or just the test program? Are you using machine pin or leaf spring sockets?