Search results

the "best" answer is to breadboard it. 2 LEDs can share a single current limiting resistor. In terms of the resistance amount that depends if you've got the superbrights or not. Start with 1k and work your way up from there. Don't be surprised if using superbrights that the resistance goes up to...

Not sure if really an "issue" since it's meant just to kill the "hiss" from other circuits. I've got this pedal and it does a decent enough job, but not enough to say "this is the only noise gate I'll ever use". I do want to try out a Muzzle and compare, but THAT chip is holding me back.

I think the "crackle" just means the gate is too clamped and cutting out wanted signal. Are you running a high gain setup?

CCW makes it clamp down harder. It’s a little counterintuitive like the filter control on a rat. Do you still have noise regardless of the knob setting?

Looking at the datasheets for a 1590A and specs at the shop for the PCB, you'll have a really tight fit if you were to lay it flat inside. Considering there are no pots you should be able to squeeze it in there just fine, albeit slightly crooked. With a lid on you won't know the difference.

I think it's due to the versatility of a SPDT versus the one dimensional SPST. The SPDT can be used as a on/off for a component, but also as a component substitution. You get more value out of a similar sized footprint. Nice build btw. My wife and I love watching our birdfeeders. Cheaper than...

You're friend's an ass. You're alright, though.

If the schematic makes perfect sense to you, by all means go for it. Some people need to write down the recipe before cooking. Others keep the recipe in their head. We all work differently. If you're the only one who will be using the test box and you know exactly what you will be plugging into...

First off, this is a pretty straightforward project and also serves as a lesson in offboard wiring. I used the tagboard test box project as a guide when I did mine, but it was not a 1:1 clone. The purpose of the test box is to eliminate as may off-circuit items from potential troubleshooting...

Where’d you get the black stripboard?

I've got this on in my queue. Does it sound "authentic" for reverb? Nice build!

Any idea what's under the hood? Got a schematic?

You're welcome. Just trying to pay it forward.

Yes, leave it out. Or install it for solder practice

The tone pot in the Eight Ball is just a low pass filter. I’d put the tone tweak right there with the input being pin 3 and output pin 2 of the tone knob

Are there no sides of the enclosure?

I've had more time playing through this circuit. Unless I'm told otherwise, 99% of the time I will play a new circuit through a crisp, clean channel on my amp. This circuit shines, IMO, through a slightly dirty amp. Sometimes you need to let your amp do the talking as well. Lesson learned.

For those of you who are fuzz junkies, the PPCB Percolation Station (Harmonic Percolator) is one of the more unique fuzzes out there using a 2 transistors (Q1 is germanium and Q2 is silicon) that feed into each other and make something very different sonically. Here is a breadboard tutorial for...

Our own @Stickman393 was super cool to throw some GE transistors my way for a few "classic" circuits. So here I decided to whip up a PPCB Percolation Station (Harmonic Percolator). Q1 had a hfe of 53 and Q2 had hfe of 174. What intrigues me about this circuit is that both transistors work...

Could just be a cold joint or stray solder on the board. Would be a good idea to clean up the stripboard tracks with your iron and inspect the pot connections to be sure. Can you share voltages?