Search results

Thanks!! SIP sockets should be fine correct?

Hello! Im trying to build the kliche mini and realized i don't have a 2.2nF film cap. Can i use a SIP socket for now and put in 3.9nf or 1.5nf?

how disappointing lol

Is anyone smart and cool able to tell what this circuit is? This is the description from the website: The Texas Flood overdrive pedal spawned from countless hours of research and development to take one of the highly acclaimed drive circuits that Cesar Diaz built for Stevie Ray Vaughan's...

maybe i should just change my amps tone stack...

I think dumping some signal wouldnt be too bad for me. It would allow me to turn up the space heater as the recovery stage and my amp to get the tubes working more. Right?....Having an extra buffer does sound good though.

Hey guys! Sorry if this question seems silly. Still new to this! Is there a way for me make a pedal that doesn't necessarily have drive just the tone stack from a fender black panel amp? I have the super stevie right now and it does a great job at those thick tones but that comes with a mid...

Im a low gain typa guy so I have a 12at7 in and it sounds so good. Running the super stevie in front of it ismagic. That combo turns my little blues jr into something else, even at lower volumes. Sounds more oomphy and bitey pushing it with the super stevie! Im not sure if it's my imagination...

hmm I got my keeley halo infront now and it's still squealing. Maybe it's an outlet problem? Pushing it with another pedal does the trick without squeal.

Even when Im running it by itself? Thank you btw!

Im getting a squeal when i turn the gain up uh oh. Sorry about how dirty the soldering is! I noticed my IC wasn't in on both sides so i fixed that and tested again. Still squealing. Then, I tried another tube. Still squealing! Please help D:

I did 240k 220k and 10k in series! Couldn't find anything on the internet after a quick scan so I coiled the leads around each other and soldered them! Looks wonky but in theory it should work i think

WOOO! Do have any tips how making the holes reusable? Once I get the pins out the holes will be blocked up by solder right? Thanks so much! Really appreciate it considering you coulda had me buy another pcb LOL.

Everyone please ignore how one of the diodes goes in the wrong hole... What is the CLR thing on the top right supposed to be? The pcb looks a little different than the doc. Also is the white side for the top caps supposed to be positive?

I got a space heater board from @vigilante398 at sushiboxfx! I was so excited to build it but realized I don't have a 470k resistor. I have most other common values. I know you can run resistors together but I'm not sure how and which values to use together. Please help :D

Not sure if this picture is any better i just dabbed some iso on it. Also I have no clue how to get the little legs out.

So.....I was trying to desolder a SIP socket I put here for a belton brick that i realized didn't fit. I think I can see a little bit of copper lifting up on the left.

Is the super stevie a TS/mid boosted? How does it have so much output? How is it different from the luxury 763?

All is well now. I feel joy. Thanks guys!

good thing i got extras :cool: