Search results
-
Forum format issues.
noticed it this morning at work .............. at home now and it's back to normal ....- griff10672
- Post #2
- Forum: General Questions
-
-
Captain Bit
One of my first few builds using PedalPCB ...... and still one of my favorites .- griff10672
- Post #2
- Forum: Build Reports
-
-
Duo Phase ( my version )
yup ..... so far so good ..... wired it following the second pic shown on the build diagram- griff10672
- Post #4
- Forum: Build Reports
-
Duo Phase ( my version )
Lot of time with the iron on this one .... Sounds amazing !!- griff10672
- Thread
- Replies: 4
- Forum: Build Reports
-
-
-
-
Some Builds that went well over the last few months ....
I couldn't find PCB Mount C25k pots ...... I bought solder lug ones from Smallbear I think it was .... and wired them in .- griff10672
- Post #10
- Forum: Build Reports
-
Some Builds that went well over the last few months ....
Sweet !- griff10672
- Post #8
- Forum: Build Reports
-
Some Builds that went well over the last few months ....
P90 LP ?????- griff10672
- Post #6
- Forum: Build Reports
-
Some Builds that went well over the last few months ....
Sure nuff !!- griff10672
- Post #3
- Forum: Build Reports
-
Some Builds that went well over the last few months ....
Valhalla Distortion .... The Betty Boost Derailer Overdrive Magnetron Delay Sanguine Distortion Paragon waddle box Kazoo for the girlfriend ... one of my favorite fuzz's- griff10672
- Thread
- Replies: 17
- Forum: Build Reports
-
sanquine distortion problem
Audio Probe it to pinpoint where the failure is .....- griff10672
- Post #4
- Forum: Troubleshooting
-
Photon Vibe Speed Potentiometer?
ahhhhhhh a alternative !!!- griff10672
- Post #8
- Forum: General Questions
-
Photon Vibe - not working
I would take a look around the " Low " pot ..... maybe reflow the solder on it .... hard to say without a glimpse of the inside .... but if your problems start right at the R1 resistor .... I would reflow the connections on your in jack and that low pot .... take my advice with a grain of salt...- griff10672
- Post #6
- Forum: Troubleshooting
-
-
Rampart Overdrive
I agree with K Pedals ...... I'm too much a newb on this forum ... I don't know how to quote .... lol anyway .... great job on the graphic and knob selection ... looks high end and classy !! !- griff10672
- Post #4
- Forum: Build Reports
-