Search results

Cold solder on the volume pot.

Put a "Tone Wicker" switch with a 3pdt.

I do not think you can use the 3pdt breakout board on the octave switch. No need to add the resistor for the octave led. It is already on the board.

For ~$4 each they better be legit J201s.

Where did you get your JFETs? I would recommend the smd version with PedalPCB adapter. Most J201s out there are fake.

Need to check the bc184 pinouts. I believe the ones from tayda is bc184L which has a different pinout. For 4393s check aionfx. They’re selling them in sets of 5

DOD pedals have buffer/s? Since the Classic 52 from PedalPCB is true bypass but I still want to incorporate a buffer https://www.pedalpcb.com/product/jfetbuffer-smd/ where do I put it? Before the pcb in? or after the pcb out?

Try BAT41

I’m about to order the board and gathering parts. How do I differentiate electrolytics and film caps using the doc? In this case, what you are saying is that C26 is a 0.47uF electrolytic cap.

In the Abider Doc Does the PCB Image on the doc match the actual PCB? C26 470n but the pcb photo shows an electrolytic. Image on the website is also different from one on the doc.

The delay knob on this one is very “interactive”. I just set it at 8 o’clock. Anything above 10 o’clock is just wild.

Try changing the tl072 and double check the power supply connector. Center negative. Check if you are getting to the circuit pin 8 of tl072 to ground.

Linear

https://www.pedalpcb.com/product/pot-insulator/

I would double check the transistors and 4558. Check if the circuit is getting any power. Check voltage on the diode. Check the voltage on the IC pin 8 and ground.

No stock from mouser CA3260EZ. Can I use CA3260AEZ as a replacement?

Check Runoffgroove Supreaux. Supreaux Deux or JHS Superbolt.

Check all the components on this section of the circuit

Some PedalPCBs may have removed buffers like in old DOD pedals or some parts replaced. I believe these are “based on” original. Would you say that the Wampler Tumnus a clone of the Klon Centaur. I believe they use is “inspired”. For me, my DIY pedals sounds better than the original because I...