Search results

A straight edge/miniature square and some painters tape can help too.

Check the voltage reg output

I can't tell if there's a mouse bite on it or not...

2399 orientation?

I got the 8oz roll with silver for $45 direct. I'm hesitant to buy from Bezos' because who knows how old the stock is.

It depends on if it's a straight.vertical shot or at an angle. I try to layout my drilling for vertical shots when able. I'll dry fit first, just to be certain I didn't screw up. You can dry fit it to test if you need an angle. Sometimes you might need 10-15 degrees. If all align, I'll solder...

I'll give it a shot. I'm overdue to replace my Kester 44. Ordered some as well as more goodies direct from ChipQuik. No promises I'll clean it though. Got some of those desoldering sticks bean posted as well.

Yeah. I don't give a shit anymore. Soldering from the topside, you'll never get it all. So why try.

Hard to see but bent into 20ish degrees on each end I did one where I bend some into a U and solder both front the top but I don't recall which one

Pin heanders are great and cheap. Much more resilient and conveniently spaced. I've started bending long headers for footswitch boards when the PCB is too small to just place the pads on the 3pdt board above the PCB(and use headers). If structural integrity is needed, 100% headers. Otherwise...

071 - single opamp 072 - dual opamp 074 - quad opamp This wins the troubleshooting section today. 741, 071, 351, 061 should all work. OP07 may even work.

I think that would be fine and exceed unity. Even hot active pups are on ~1Vp

3.5-4Vpk is really about the max you can get out of a non-R2R opamp at 9v and pretty loud. That's way above unity gain, even with hot/active pups. I would think 2.5-3Vptp would be more than suffecient and even that may overload following pedals, depending on their architecture

Hey Bob. I know it's usually just once but any chance we get another 25% off for New Years for those slack jaw hillbillies that slept through the last sale? Asking for a fellow troglodyte.

If Rivera era fender made an overdrive Excuse me. UnDeRdRiVe.

Gotta power the LED but I think Aion has pads for that. I would advise against mixing daughter boards between ppcb and Aion if you e just been doing kits. They each have their own way of doing things. It's doable but odds are you'll end up in the troubleshooting section before it's over with.

Ive thought about getting the WEN 3410 Walton's 5 and Dime has it for $115 currently. It's 150 direct from WEN They have hepa filter units too. Not sure if they have hepa filters for the 3410 but I'm betting 1 micron is enough for most use cases Edit, these are sold under a few brands. Grizzly...

I failed Art 1 in high school, which I didn't even have to take but did because I wanted to and was fairly artistic. Our midterm was a watercolor piece. We had to watercolor underwater sea life. I didn't want to water color fish. I asked to do something else. Denied. So, I watercolored and...

Why not use a 2 pole switching jack? (Insulated/isolated) I don't know that I've ever seen a single pole switched on an amp output. https://www.parts-express.com/Rean-NYS2122-1-4-Mono-Jack-Switched-092-120?quantity=1 At 5-15w, this style should be good. Though, I like speakon connectors. A lot...

The Boss?