Search results

Are you using toner transfer? I find I don't get great detail with that method. I used to use the UV photo resist material with better results.

It is cool, it got buried by new stuff.

Did you see the project development section on it?

I got a broken fuzz factory fixed it and just never really liked it but I was a tasteless then so maybe I should flip it and build my own. I have tested NPNs for pretty much exclusively muff builds I am interested in a tone bender. Honestly now that I have a clean amp I understand what people...

Oh wow so many to look up. It is like a whole new world basically I got a hyper fuzz and a muff and was like naw I am good here. Thank man.

Are you using it like a preamp?

This is the valuable info I am after I will look into it thanks! I am not super knowledgeable when it comes to fuzzes except some muffs so appreciate it.

Have a bunch of Ge PNP transistors sitting around looking for some recommendations for builds. I know there is the Arbiter Fuzz Face anything else?

I used to use a low quality DMM for a long time just a cheap harbor freight DMM. It can even test some components which is nice.

Probably sound like a broken record on these builds, but yet again the 3pdt soldering looks suspect. This is how I do mine when I use a board.

I see some germaniums in there that will cause a volume drop, not sure how you laid them out. I usually use four diodes in series like this. You could always experiment, this is just one combination that works but you still get a slight volume loss.

Everyone has their way I guess, but I still stand by my statement that the soldering on the 3pdt look sketch.

Unless it is a super bad quality 3pdt it should be fine I run my iron around 375 and it takes a brief hit to heat it up and then I fill it in. It might not/ probably is not the issue but it would eliminate a potential problem.

Your 3pdt soldering looks suspect need to fill in those bad boys.

Yeah the earlier versions of the Palisades did this as well. Most of the earlier boards I made had this issue I partially fixed it with optoswitching. I guess you could add the clickless board as a add one.

Muffin factory is pretty ace.

This is a version I made that had switches which allowed you to switch between independent boost or overdrive on then boost, but honestly I found the boost pretty meh. Felix doesn't have anymore of these board that I know of but maybe future improvements. Also the size of this is much better. I...

IC 1. 4.48 2. 4.49 3. 4.48 4. 0 5. 3.99 6. 4.49 7. 4.51 8. 8.92 Q1 1. 3.942 2. 4.47 3. 8.92 Q2 1. 3.94 2. 4.47 3. 8.92 Let me know if you need anything else

It cuts a bit of bass most good overdrives do but mine isn't shrill or bitty and I use it on bass. I would describe it as smooth and warm. I would check out everything again I can get you voltages if you need.

When I make my own faceplates or using a slightly inaccurate drilling template I make my pot holes 5/16' so everything fits together easier. With washer, nut and knob you would never see that slight gap.