Search results

Hi gang, I've got a Kliche mini that ouputs a low signal and doesn't make any distortion. IC voltages seem fine and the resistor values I've checked are all correct. Anybody see anything I'm missing?

Finished this triple-pedal last week. SUPER happy with how it turned out. The switches above the stomp switches let you switch the order in a couple of different ways: The switch on the right lets you put the Katana before/after the distortions. The switch on the left lets you decide which...

Got it!

Thanks man - solid. I thought this would be the case, but wanted a second set of eyes looking at it.

Question - where would I wire the grounds of the input/output jacks?

Yep. Same problem! Thanks for the pics over on your other thread. I’ll give the old “bend it ‘till it fits” a try!

Hi all, I'm trying to source some 3pdt on/on switches that work with Pedalpcb's Order Switch PCB. I've picked some up from Amazon, but they don't fit. Anyone have a good source for switches that fit these PCBs?

Ok - now I'm just getting BONKERS. I think I'll be able to fit the Katana just fine. Here's what I'm scheming next: How about using TWO order-switching switches to give me the following options: Switch #1 - Katana First or Last (Pre-effects Boost or Post-effects Boost) Switch #2 - Blues...

Thanks for your patience - this community has been a godsend this year.

This better? Ximimark 4Pcs MTS-302 3PDT Mini Toggle Switch ON-ON 9 Pins 2 Files 6MM Rocker Switch Red Latching MTS-302 https://www.amazon.com/dp/B07GWGN6D4/ref=cm_sw_r_cp_api_glc_fabc_kLo1FbZCP739S?_encoding=UTF8&psc=1

Agreed! I picked up these switches to work with the order switching PCB: https://www.amazon.com/dp/B07VK7GWVQ/ref=cm_sw_r_cp_api_glc_fabc_4Uf1FbSQSWF8M Think they’ll work? Im also a bit flummoxed by the switch used for the katana. The PCB has six holes for where the switch needs to go. I’ve...

Thanks for the reply - It's nice to have another set of eyes take a peak at what I'm trying to figure out. Really boosts the confience. I may not go for the three pedal build as it kinda messes up the layout I have planned. When I saw I had room for a third pedal, that's why I thought about...

Hi all - I started as a complete noob over the summer and now have a half dozen pedals under my belt. Thanks for shepherding me through the learning curve! As often happens, I see a little success and think I can start innovating! I'm thinking about housing three pedals in one 1590XX...

Haven't seen these in stock for a while - does anything Tayda sells work with their predrilled holes for 3mm LEDs?

This community is incredible. I really appreciate that I’ve had multiple people reach out to me.

Didn’t even think of that. I’ve got a different adapter I’ll throw on there and see what happens. not sure about the diode reading. I’ll check it again and report the findings. Thanks!!! POLARITY! That was it. Thanks for the assist. Just played some solos through my first pedal build. Sounds...

Reflowed, rewired and still nothing. No LED, no signal when engaged, signal is fine when bypassed. I’ve got power to diode at the top, but nothing to the IC. Here’s a pic of the power wiring:

I snipped the power leads to get at my board more accurately. Do these solder joints look any better? I think they do, but I thought my first joints were ok too.

9v battery. Reflowing as I type this.

Removed pots and wiring so you can see the board better.