Search results

Hi all - in the Overdrive Special PCB there's a switch labeled Rock/Jazz. In the schematic, it looks like one side of the switch goes to ground and the other goes nowhere. Which side would be the "rock" and which would be the "jazz"?

Hi all - I'm trying to use EasyEDA to build an effect and am a bit stumped by the 3PDT stomp switches. I've grown SO accustomed to using @PedalPCB 's breakout boards that I've never learned how they actually ought to be wired up. Does this look right? I'm sending this effect to an order switch...

Hi all - I'm trying my hand at PCB development and decided to start with a Keeley Katana Boost. I've got the thing just about done, but the 2N5458 semiconductors aren't available at jlcpcb. Any ideas?

Hi gang, I've got a Kliche mini that ouputs a low signal and doesn't make any distortion. IC voltages seem fine and the resistor values I've checked are all correct. Anybody see anything I'm missing?

Finished this triple-pedal last week. SUPER happy with how it turned out. The switches above the stomp switches let you switch the order in a couple of different ways: The switch on the right lets you put the Katana before/after the distortions. The switch on the left lets you decide which...

Hi all, I'm trying to source some 3pdt on/on switches that work with Pedalpcb's Order Switch PCB. I've picked some up from Amazon, but they don't fit. Anyone have a good source for switches that fit these PCBs?

Hi all - I started as a complete noob over the summer and now have a half dozen pedals under my belt. Thanks for shepherding me through the learning curve! As often happens, I see a little success and think I can start innovating! I'm thinking about housing three pedals in one 1590XX...

Hi all - thanks for your encouragement and help as I embarked on my first pedal build. I grabbed, PedalPCBs Mahayana Drive (Zendrive) and followed the guides available in this forum. I also followed The Tone Geek's video of his build of this same PCB. I ordered the wrong potentiometers with my...

Hi all, I picked up one of Tayda's ILLUMINATED PUSH BUTTON FOOT SWITCH 3PDT BLUE COLOR LEDs and am looking for some help on how to wire it up. Here's the wiring diagram from the Build Doc: I'm hoping to use of PedalPCBs 3PDT Breakout Boards, but understand if it doesn't jive with an...

Hi all, What an incredible community. I've lurked on these forums for a while, but will finally swallow my pride and start asking questions. I'd like to start my DIY Pedal journey with something easy. I've gathered that doing a ZenDrive clone (Mahayana) will be a good place to start. I'm...