Search results

Solder these to the PCB then just stick the components in the hole or solder both?

Thanks, I'll get some. Do resistor, diode and transistor leads fit the holes snuggly enough to make good circuit connection?

Thanks!

I use sockets for my ICs but wasn't aware of sockets for diodes or resistors 😵‍💫

I'd like to but I'm not great at removing and replacing tiny components.

I'm building the Six String Stinger pedal and trying to decide whether to use the indicated in5817 diode or sub in a germanium D9K or D9G. I have all three on hand and can't decide. Any suggestions? I used germanium on my Zen Drive and really like it. I'm using Fairchild jfet j201s. Thanks I

Thanks

I have my Blue Shoe build just about finished and I would like some advice on how to set the jfets to 9 volts while the pedal is powered up. I haven't been able to find a video that helps. I would appreciate some instruction. Thanks

I may try various different ICs to pick a favorite

I finished my Mahayana pedal and it sounds great BUT the noise floor is a bit excessive. I've read where this circuit is prone to this. Do you have any suggestions for fixes or know what the source is? Thanks

Even if I tried to straighten the legs, the chip is surely damaged 😞

My OPA 2134 IC from Stompbox parts came to badly smashed. I hope they replace it.

Swelchy, Are you referring to the TL072 IP or the TL072 CP for the Mahayana IC build? Thanks

Thanks for all the help, I'll keep working on it

I fixed R102 ..... Still not working. When I touch the PCB on bottom of stomp switch it hums and occasionally pops. Could be a solder short on the poles beneath the PCB? LED still works and the bypass is fine.

Thanks, I'll keep working on it. The power supply both battery and power supply are 9v. What is VREF? Anyway to check the ICs in or off the board? Thanks

Will do

I checked the IC voltages 1thru 8 Ic1 7.26,7.26,6.58,.000,7.24,7.28,7.24,7.77 Ic2 7.28,6.68,various,.0007,.25,7.25,7.25,7.77 Ic3 7.27,7.27,7.25,.000,.007,7.25,7.25,7.77 Ic4 7.21,7.24,7.22,6.12,5.62,5.68,7.13,7.77 Okay?? Also get a faint fluttering noise when I turn trim pot and when I touch the...

Hope this helps. By the way, there is a popping sound when I press the switch to turn it on. LED still works and the bypass works

Will do with better picture