Search results

I have this one https://www.amazon.com/dp/B013IFC6N2/ref=cm_sw_r_tw_dp_x_J-XiFbJC37MBR

I own one and the "neutral" on the ac outlet really isn't neutral just a hole. Ooops yours don't have the neutral hole on the AC outlet. I use at a psu when I troubleshot my pedals.

I have 3 DMM.. my Fluke 189, a Craftsman which is about 25 years old, and a LCR/DMM Made over seas. I will always purchase a Fluke just because I've been using them since the 80s and they have always been reliable. My Fluke if for work, my craftsman is for home, and my LCR/DMM is for when I...

I got them ebay about 8 years ago and they were in my original Fuzz Face Clone. I don't remember leakage measurements.

Nope.

Thanks. I'm probably going to just try NPN..

anyone?

For ground(earth) I'm going solder all ground to a washer of the input jack.. The LED I was thinking just putting it on SW and GND on the Switch lugs that protrude through the breakout board.

Yes I did.

https://www.taydakits.com/instructions/fuzz-face/pages/enclosure-and-wiring--21 This was one of my first pedals I built, but robbed it of parts at one time. Now I'm putting it back together. My question is how do I wire this using a PCB 3PDT breakout board and I'm using Ge (PNP). Minus the...

I went to check the biasing of my Twin Face with the trim pot fully CCW I can only get it to -5.35v. Bad trim pot?

That graphic is bad ass!

Don't have a 50k... was going to take one of my 250k and use a resistor, but the pots should be here by Thursday.

Well I started mine and about 90% with it. .I didn't double check my order and didn't notice I only ordered 1 A100K pot. Ordered one today and hopefully I will have it by Thursday.

Strategically placed radial cap. :)

Nice!

I use gravity as well and use these https://www.harborfreight.com/test-probe-set-5-pc-61872.html just heat up the solder put the pick and turn it a little, the solder doesn't bond with the pick.

Maybe a piece of plexiglass. I received my PCB yesterday, but will start to populate it this weekend.

Like these two....

Haven't received the board yet, but have been working on the graphics. My graphics creativity isn't as good as a lot of you on this forums and I can't wait to see other graphics. Hopefully I will get my board tomorrow and start it. Here is what I came up with.. it's a little bland, but it...