Search results

Yeah it's not too bad, but unfortunately not good enough to have scales around the knobs which I had in the original design

Please ignore the white washer that hides the too big and off center hole for the footswitch... Great little tone sweetener, I've mostly used it on the end of my effects chain and it's one of those effects you only notice when you turn it off. Not a lot of boost but great tone shaping I botched...

I just wish my drilling was as centered...

Thanks! I like the design but the waterslide isn't perfect, you can see the logos at the top and the text at the bottom are "leaking" red ink I need to find a solution for that, I read it could be the printer using RGB for black, or too much clear coating

My first PPCB build is my first build report I've had the Chop Shop on my board since solving a couple of problems as documented here: I had to rebias it a couple of time to get rid of squealing with high gain+sag, maybe because of the through hole J201s, and I had to add a pulldown resistor to...

I have a Slotva and I quite like it. It has 3 nice reverb algorithms, quite easy to dial in, and it can save 3 presets. If you like FV1 reverbs it's very nice The Julianna is an expanded Julia (Ppcb Caesar) with tap tempo, stereo and other bells and whistles

did you end up solving it? I too am using Hayes inkjet clear paper and am having the same problem with black ink "smearing" with a reddish hue

I seem to remember your username from the old Fennec Electronics forum I was mostly a lurker but it lured me into DIY pedals, I still have a couple of saved projects from there

Nice execution and idea!

Great artwork! I remember you're from Italy, do you still order UV printed enclosures from Tayda? How does it work with import and taxes?

What are talking about? Says right here, "from new jersey" so it must be real and not British

I have the v1 board but it has plenty of gain, gets almost fuzzy when cranking gain and sag

Good ideas, i still have to try it before boxing so I'll keep in mind the R12 tweak. If I understand correctly, it's in a feedback path right?

Thanks! I'll give it my first try this weekend

I am finishing up one right now, first experience with smd soldering, it didn't go as bad as I thought 😅 Why did you sub r12? No unity even with the gain trimpot? Also, did you just install the pots backwards to fit it with top jacks?

quick question before I try my first waterslides, do the enclosures need some prepping? cleaning, sanding, something like that? or is it worse?

I installed a momentary SPST footswitch in my Cataclysm build, following the advice in this thread, adding a 25k trimpot. Not noticing that the Magnetron "feedback" pot is 100k, while the Cataclysm "repeats" is a 5k pot, so the oscillation switch only works when the trimpot is almost all fully...

Also, Musikding only carries a kit if there's a build doc for the project 😬😬😬

Thanks! I think I'll put a socket and try some stuff. Leaving c6 as 100nf would put the caps on the switch as parallel right?

Would it work as a Vibrobot speed selector switch? as described here