Search results

All good points. I’ll be home in a few hours and will upload schematic. Thanks for the discussion.

Morning. I breadboarded and then built this point to point pedal. I’m only getting bypass at this point. Any ideas? Thanks in advance!

So what would I connect to the SW on this breakout board if I'm doing a stripboard circuit? As far as I know, the available wires out of the circuit are 9v, G, In and Out

Bad potentiometer. Sorry for any alarm I may have caused.

Hey y’all! Big ask here. But, i’ve been working on this 69 NPN, full tone, fuzz, schematic I bread boarded it, and I get clean bypass sound on both the effect on and effect off. Not sure where I’m going wrong. It seems like there just isn’t any effect at all. I know it’s a lot of wires and...

That did it. Thanks!!

I’ve been working on this strip board version of the Reeves ZO. I’ve gotten everything in. I think I’ve followed the strip board diagram correctly, but I’m just not getting anything except for bypass. I know the wiring and stuff is a little messy, but it’d be great. If you could give me some...

Here’s the wiring diagram.

Hey there. I was wondering if someone could me out with the off board wiring for this strip board version of the Reeves Zo. I have it all built and I get bypass signal, but something is up with my wiring to the 3PDT/input output jacks. I’m using the attached wiring diagram. But I was a bit...

Tried it out. Thanks Robert. Tried what you said and everything works. Must be my vero. I’m guessing the way I had it setup was correct though right? I’m going to dive into fixing the vero, but wanna make sure I at least had it setup on the auditorium correctly.

Just put together this little fuzz face and wanted to test it on the Auditorium Test Board. I’ve never used the board, but thought it was a good time to try. I must be missing something. I think I have everything hooked up correctly and yes. The power and in and out jacks are usually hooked up...

That did it. Thanks!

So, I built this Aion FX Flare (Fuzz Factory) a few months ago and love the sound. The problem I had was that the LED never came on. Well I revisited the pedal today and realized that the Aion breakout board had snapped the connection between the LEDR and the 9v power wire. Either way, with that...

Not sure. He just described it as affecting the mids. Thanks for the detailed description though.

I tried it and actually loved the sound. I'm just trying to figure out exactly what that pot is affecting. Is it Q1, Q2?

Sorry. Here's the schematic I drew and breadboarded. This is what I was thinking.

Got the idea from an Aion kit. Here's the schematic. Looks like it's to mess with the mids a bit.

So, in your opinion, what would adding a B2K pot between R2 (33k) and R3 (470R) do in a fuzz face?

Perfect. Thanks

Does anyone have a source for clear broom plates for pedal enclosures? I’m going point-to-point and would love to have the bottom transparent so you can view the guts of the pedal. Thanks in advance