Search results

This is the most riff specific pedal since the fortin 33. 0101101011011

@PedalBuilder REACTS to pedal-builder REACTS to Uncle Roger REACTS to Jamie Oliver Fried Rice Episode Fu-Yo!

LOL Studio One is now Fender Studio Looks like they threw some more guitar based plugs in there

It should burst.

Make sure you aren't missing a link under the caps on the right. Can't tell. Also, with power removed, check resistance on each side of you cuts Schem via madbean

I'm not sure that opamp is rated for 300 volts.

Red rocket! Red rocket!

BC 213, BC 258, BC 308, BC 558

No. That would be a faraday hat. Everything needs to go to ground. Cracks are way worse than holes. Any crack will allow rfi passage of a frequency with a wavelength 4x it's length. i.e., 1 Ghz is 30 cm, so it and any frequency at or below 1 Ghz could pass through a crack of 7.5cm. If the...

Congrats! A lot of troubleshooting threads on that one across multiple forums.

Yeah. They don't do low pf. I usually grab a 100pf or the like and parallel them for anything sub 50 or so. The adcopy claims 25pf-100u I can only imagine that on the edge of capability isn't that accurate either.

Are you feeding it a particularly hot signal? Once you extend the opamp as far as it can go, you won't see much change. This will happen way sooner in the rotation with active or hot pickups or most basses A parallel resistance with the pot could help this and is easy enough to test with a pair...

8.3V output!?!

Does it DOOM?

1) https://circuitdigest.com/calculators/lm317-resistor-voltage-calculator

SM7B is really a killer mic, still. I'd almost say make that your second mic purchase, but it's a bigger investment than a 57. But, you can use it on everything. I would grab it before a cheap condenser. You can also make some decent sounding electret mics for pretty cheap.

Motu and RME are probably the best about maintaining drivers for a LONG time.

No need to delete. May help inform someone else in the future

Did you buy this for each enclosure? https://www.taydaelectronics.com/125b-custom-drill-enclosure-service.html

What do you want to do? What are your goals with this setup? What's the biggest use case you can think of? Just at home, or possibly mobile? (You may want something bus powered if mobile) I wouldn't get a 476, personally,.but it looks cool as a "good 2 channel interface with different flavors...