Search results

You can also try a 1u cap along the wet path before the mix pot Try removing the vol pot and see if you have mix pot issues

Take it as a compliment, good sir!

in other delay circuits, the level control doesn't follow the blend control directly, rather it's implemented differently - there is either a level control for the delay only before it joins back with the dry path or there is a mix control in lieu of a master vol control. I would remove the...

You could breadboard it to isolate the circuit from the PCB and determine the crosstalk issue

I would start with a fresh look in the morning and if nothing jumps out at you, I would remove the tone control setup and check if the rest of the behavior is the same (wet/dry being off, repeats still there in weird situations) Then remove the mix pot and directly wire the wet and then the dry...

When your bit hits the box every fraction of a millimeter counts!

Your analog pedals can be daisy chained together, but digital pedals should get their own power cables. I use a Voodoo Labs Pedal Power X4 which means I can daisy chain a number of analog pedals and have 3 digital pedals.. but I don't have any so it's all good :) @Robert Can we get a DIY power...

Your clipping LED's are missing. Also, try setting the BBD trimmer somewhere in the middle to start

That's what I figured - when the smoke is in front of your face it's the most concentrated, in exactly the place you don't want it. In my basement the room is so big I don't really have to worry about an exhaust, but if I was in a bedroom I'd be a bit more concerned. Maybe a stronger fan +...

The two middle solder pins are the LED circuit and ground

I would go ahead and order the correct one. You've waited this long already, what's another week?

I removed the filter on mine today and the fan's draw range was doubled. I'm leaving it off. It looks like yours.

When you use these, you also need to place a jumper across the LED pins on the main PCB, as well as the CLR on the main PCB. Or, if you've already installed the CLR on the main board, then place a jumper across the CLR pins on the breakout board. If you get the distance from the switch to the...

get this one The 5mm is the diameter. The other dimension doesn't matter for this. But there is enough space around that cap to use a 6mm cap. Just use anything 16v or higher.

An exp out jack would be nice to incorporate with an expression pedal, but I'm not sure if it would fit the theme of one mashing just one pedal to get an instant lead tone. Maybe there could be a couple toggle switches to attain different "parked wah" freq peaks. Or maybe there could be a...

That would be pretty cool! In the original Bluebird, there was only one knob for the delay function. I'm not sure what it adjusted, other than the level of delay. Perhaps as the control was turned CW it also increased the number of repeats, or maybe there was a set value for repeats and time...

I was thinking a tube screamer type circuit as the idea of the pedal is to mash it on for the guitar solo. Or maybe a Hot Cake?

I was thinking about this too, and I considered heat shrinking or hot glueing them, but they are so stiff and there's about 1/4" clearance between them and the board, and everything else they are attached to is secured in place. The back end of the board is hot glued to the TL072 below it so...

I put this together for a customer who wanted something like the Mad Professor Bluebird - an overdrive pedal with a delay built in for guitar solo type stuff. I had the Southern Belle already and build the Seabed Delay to accompany it. I managed to get it in a 125b by stacking the boards. The...

This is awesome! I built a Low Tide, but had the same results with the gate control - it was only useful when turned up all the way, and the LPG didn't do much for me either. If this makes its way into a PCB, I'd love to build it!