Search results

You can get TL072's from @PedalPCB, another good reliable source.

I Try to buy my IC's from Stomp Box, Digi-Key or Mouser, especially the ones known to be popular to fake.

I had already sealed the package, so I slit the top enough to drop them in and taped it closed. Will try to get to Post Office tomorrow.

Seems like I bought some subs for the 2134's a few weeks ago, if so, I'll throw a couple in the package with the transistors.

How many do you need?

Inkjet waterslides is why I went to a LaserJet printer!

That's what I use white washers for!

Digikey is where I found them.

I have some of those incoming. I can send you a few when they get here.

Couple of those solder joints like the in jack to the board look suspect.

Ditto on the Ditto

Free shipping direct from their site: https://www.thepedalport.com/the-pedal-port

I try to set my temp to the task, soldering a board I'll run at 700, desoldering I generally drop down to 600, SMD maybe even a tad less.

When the solder feels sticky you need to clean your tip

I don't think I've ever worn a tip out, I have switched types a couple of times, pencil tip to chisel and back to pencil. On my old Weller 25 I did have to replace the collar that secures the tip once.

What size rolls of solder are you buying? I've been using the same 1 lb roll for at least 10 years and over a hundred pedals? I'm just about to start my second roll.

The masking service Tayda now offers cuts way down on paint inside the enclosure, you still have to clean out the drill holes though.

The Remington stuff isn't Pre-Bond, but the tubes and more wire description sounds pretty good, seems to state it's pre-bond

They aren't the same, the insulation on LMS wire is thicker, I use it on builds when Barry's wire slips through the hole insulation and all!

The pre-bond I get from LMS and GuitarPcb it's the case, rarely ever get a stray wire.