Search results

This should work. You will have to do a little work though. You may just be sble,to replace the one wire. If not you can get an extra screen and I can verify that it does work...

So I didn’t really have any expectations going in. I generally don’t like tons of knobs on delays, I like them pretty straight forward. This one, with some fiddling, got some really nice delay sounds. It seems like it could be really versatile. On the other end there are some settings that are...

Yes, the longer screws are for the 125b. It should be pretty snug and not move at all.

Fixed. Not sure what was going on.

I need to figure this out. Right now i have edited a 125b foot print that has knob placements etc. i i place it temporarily so i can have my pots in the correct place. It also helps me draw the board within the correct dimensions. In eagle i had the hole board pre done based on pots. Already...

877 cash now

Ty ty Ty

Thanks Robert. I will give it a look.

I finally found it but the it only shows on the pcb layout side not the schematic side. It also doesn’t pop up a box like it’s supposed to. I read about it on the guys GitHub and it may not support newer versions of KiCad.

So essentially build it just like symbol (KiCad terms) and place it like a part. That would probably work. I have this plug in installed but have never seen where the plugin actually is. It doesn’t load in the top bar like all the other plugins I have installed and I can’t find it in the menus...

So I was wondering how to do circuit snippets? I know there is supposed to be a way how but I have no clue. What I mean is there are certain things that I use on a lot of circuits that would be a lot easier not to have to build each time. For example the power section or my off board wiring...

This is a great write up! One thing I might suggest for your first few times doing a fret level is to get a radius block to do the initial sand of the frets. It will take less time and be less likely to cause high and low spots vs using the smaller beams. Make sure it matches your neck radius...

I found it finally.

Title says it all. Anyone have the KiCad footprint for the 3p4t alpha switch from tayda? I can make it but prefer not to if someone already has it.

I like Roberts little cheat lists for this very reason.

If you want to drill yourself any of the standard 4 knob templates will work from the pedalpcb shop. Look at the drill template for the nein fuzz. The drill template is a standard 4 knob which is what is linked above for tayda. That will get you the coordinates for Tayda to drill it. You have...

I did the same thing. Loaded up on knobs and jacks.

You shut your damn mouth sir!

That being said. I love the interactive Bom from KiCad as a supplement. It’s nice to have that up while I’m building.

I like the pdf. I download all build docs for every project I do in case I ever need to reference it at a later date. That also means I have the right version to reference even if a newer version replaces it. Just my 2 cents.