Search results

I purchased a UNi-T UTG962E for around 100.00 a few years back.

I have a rule if it can be done and cost is low. I will do it.. :) cost me 15.00 for a pound of rosin and .99 for Alcohol. I have enough rosin that my Great, Great, Great grandchildren will have some ;)

Isopropyl and Rosin Here's a video I came across when searching about it being sticky.

I made some, but it's sticky AF. Works good, but have to clean it after using. I might add some glycerine to try to firm it up.

My favorite by far has been Kliche... It's the one that I have used the most and always stacked with others.

Yes, I have the SMD pad. I will clean it up and test it again. I guess the 2N3904 is too low of a gain for this pedal?

My LCR-T4 is fubar'd 2N2222A with the meter hfe = 431, using the bread board = 270 2N3904 with meter hfe = 430, bread board = 127 BC337 meter = 430 - bread board 244 S8050 meter = 420 - bread board 160

LCR-T4 Mega328 ... My DMM is being a pain and will have to get my fluke from work. For some reason it's not reading µA and the mA is sporadic. I'm using a 470K on the base with a 9v input. Going from E to GND and then putting 9v into the C to GND and not getting a good reading either...

My DMM and Transistor tester is wrong as everyone of my NPNs are 280+ hFe.. My 2N2222A are all 480+ hfe. I got some from Tayada, Mouser, Newark, and Amazon.

Mixing NPN will it make a huge difference or should they all be the same? For example 2N3904 and two 2N222A.

Thanks, but that still shows the rotary switch. My version didn't have the rotary switch and pretty sure the silkscreen Diodes were incorrect.

I decided to troubleshoot why I'm not getting any changes from toggle switch in the middle position and the toggle being in the up position.

Some kind of hornets nest I snapped while I was in Cancun. If you can't tell I zoomed in.. wasn't going near that thing. I didn't want to get impregnated by an Xenomorph. :)

I get my magnet wire for my pickups and my hook-up wire from Remington Industries

Nice. I have to finish mine... just deciding if I want high gain or not.

I got one of those and I ended up letting the smoke out. I even printed a nice cover for it and that melted a little..... too much power over a fairly long period and I lost :)

That explains things. I wonder why he had such a huge follower base.

Reaction video.

I tried this one, but realized that I F*** it up after I solder all the resistors on and so now it's been sitting my "junk" box for the past 3 years.

Use to do a lot of work at the airport. One of my amps was built by a person who lived out in Irmo, unfortunately he passed away. We grab dinner at Lizzard's Thickets in Irmo and then drink a few cold ones at his house. Check out his work bench of amps and would jam a little. good times...