Search results

The DC7 or DC8 would work, but it’s about $100 over my meager budget. If I can find a used one I might be able to swing it.

Already has rubber feet on it. I suppose I could get bigger ones. I may be able to get a thinner power strip and save myself 1/4 of an inch. Everything would just fit, but I’m still essentially stuck using 4 wall warts. none of the power supplies I’ve found offer 12v at the right amperage to...

Thank you! I have 2.5 inches of clearance at the back of the board so can fit most every commercially available power supply, except the ones I already own

Osh Park does pretty good small runs: https://oshpark.com/

I am looking to pick up a new power supply for my pedal board, but I’m on a somewhat tight budget. Currently I am using a couple of onespots, which work great, but my new board doesn’t have a ton of clearance for a power strip and the suppluse to run under the board. i am running the following...

Thanks again! My meter doesn’t have a continuity tester, so I’m going to pick up a new one to make this easier. If anyone has recommendations for an affordable meter, I’d be most appreciative. I will try the trick with pulling out pin 1 of the ic and get back to you. here’s a video of the...

They are. I have Three different brands on the chips. I think something is still wrong as there is a very harsh clipping if I play hard. I’ll see if I can get some sound samples posted later

This seems weird. I must have tried 20 different TL072. None worked. I plugged in a 4558 and it works. If I play hard it clips voltages are: pin 1. .89v Pin 2. .89v Pin 3. .72 Pin 4. 0.00v Pin 5. .82v Pin 6. .85v Pin 7. .87v Pin 8. 9.09v Any wild guesses here?

Ive checked for shorts and bridges, but can’t find any. The part values are all correct per the schematic. below are additional voltages on the TL072: pin 1. 1.4v Pin 2. 1.41v Pin 3. 0.95v Pin 4. 0.00v Pin 5. 1.05v Pin 6. 1.17v Pin 7. 1.41v Pin 8. 9.09v Thank you,

Thank you! Below are my voltages FV1 pin 13 3.23v 4049 pin 1 3.3v tl072 pin 8 9.09v Pin 3 of the tl072 I have clean audio Pin 1,7 and 5 give me broken intermittent sounds. I swapped out the chip and got the same thing pin 2 FV1 give me the same broken audio Pin 1 nothing pin 27 broken...

Hello, Just finished up a Deflector Reverb, and I’m getting no sound. Bypass works fine, but nothing when active. The L78L33 gets warm/hot to the touch, but I’m not sure if that’s ok or not. Everything is socketed, including the regulator. I’m powering this with a one spot. Does anyone know...