Search results

I really like the nuts on the in/out jacks... are these part of the jack or bought separately? Which are they?

How does the footswitch board work then? With the input buffer (2n5088) in circuit all the time, the output would only be a single set of footswitch pins with another set for the LED to ground. Could this not just use a DPDT footswitch instead of a 3PDT?

in this build?

which BC108? 108B or 108C?

I noticed a changes between the first Twin Face in 2018 and the current version. Instead of sharing the 2u2 cap at the input, an additional 2u2 cap was added and so that the input goes to the switch and no shared components. The polarity of the two 2u2 caps are reversed (NPN vs PNP). Did...

I proto-built the Propolis schematic on the PedalPCB ProtoBoard (Which is amazing BTW).... It has a volume drop at the attack and then comes back up as the signal decays. I have double checked all values and paths - all is 100%. Tried different transistors in case one was bad... no...

I wonder if the 4148 was a mistake in the original ...

Has anyone who has built the Derailer noticed the amount of volume increase when switched to 4x12 mode?

Did you work out a solution? I found the same issue in the gain pot being a linear pot. I am going to replace it with a Log pot to give it more sweep in the lower gain section.

Thanks, that is pretty much what I thought as well.

Would a 22uF e.Cap be a problem or is the 20uF required?