Search results

Did you find a solution for this?

Hmmm so this is my problem right now, one of my footswitch wires is soldered onto the top instead of through the hole (desoldering could not get rid of the previous botched wire I mounted in there). I'm wondering if this is the problem. I may also buy a bag of heat shrink to really insulate as...

I'll try both of these, thanks for the response on this

So far I've checked all my resistors*, caps and ICs. They're all where they should be. *I did at this point notice that I mounted a 22K resistor where at 27K resistor was meant to go, I didn't have any on hand so I made one with 22K and 4.7K in series. This problem happens regardless of...

I hope nobody minds me bumping this

So the dual channel pedal sounds great and works in all aspects, one thing I’m noticing though is turning the bass pot up on the high gain channel passed a certain point causes sever high pitched feedback. Just wondering where I start here, have I misplaced a component? Let me know if you’d...

Hah, actually I had two tabs open. The Triangle build report and this one, both have backwards transistors and didn't realise I'd only read one of the build reports (evidently the one that doesn't mention why the transistors are backwards), thanks for pointing that out

Hey @MichaelW , coming in with a beginner question here. I noticed your transistors are installed backwards, i bought the 2N5088 from Tayda, are yours a different type of transistor which is why they're installed backwards or should I be following suit?

Thanks, you can find what I mean here: https://docs.pedalpcb.com/project/MuffinFuzz.pdf I'm seeing here now that it's a resistor, however interestingly enough I'm not seeing where LED actually goes, what am I missing?

Hey team, so just a quick question about my next build. I'm seeing the bill of materials says "RLED 4K7", is this just a standard 3mm LED on Tayda or should i be looking for something specific?

Did this end up happening?