Search results

You can make a new thread in troubleshooting with clear pics of both sides of the board!

Do you actually own that little desk organizer / solder holder thingy? I found it on EveryMarket but I am hesitant to pull the trigger...

🙄

Ah right! Sorry I was thinking A taper only.

Trading cards organizer sheets in binders work very well for resistors, capacitors, diodes, transistors and even PCBs (I have multiple sized pockets). For the rest I use Akron Mills containers.

The slope of the A taper is small at first and then steep. The B taper with the resistor in parallel is almost exactly the opposite: steeper at first and then it goes down, becoming almost flat.

Oh so like a looper? I think there are folks on the forum who have done that, try searching for pedal looper.

Thread 'SWITCH-CRAFT (got any creative uses of switches?)' https://forum.pedalpcb.com/threads/switch-craft-got-any-creative-uses-of-switches.19642/

Wdym by pedal switcher? The JHS seems simple enough to make with some jacks and passive switches, it doesn’t look like the loops are active? There is a thread about switching you could check out, let me see if I can find it.

For white on white, I think the best thing to do is experiment. Or search the forum for other people’s build reports to see what they have done. I don’t think the white layer costs extra money (?), in which case having it won’t hurt. As far as the pdf template, I don’t think it’s necessary at...

Very nice build! I like the color a lot. I really appreciated the write up about JFETs, I learned a lot!

Painters or electrical tape has got to be the top cause of troubleshooting threads! :)

Painters tape is not gonna help. Electrical tape is also usually ineffective. Try a small piece of thick cardboard or, if the board is outside the enclosure, try lifting the pot a bit to see if that changes anything. Some of the solder joints look like they may be cold but it’s a bit hard to...

Robert had shared it in another thread I stumbled upon.

Also https://docs.pedalpcb.com/project/Schematic-3ChannelMixer.png

If you already bought the PCB, you can easily tell from the component outlines printed on it: circular caps are electrolytic, the rest are mostly box caps and the lowest valued ones (in the 10s-100s of pF) are ceramic.

But which dioooodeess?!? 🤪

I haven't tried the D&M drive but whenever I hear it on TPS I always like the way it sounds. I thought there was a PCB for this somewhere? Did I dream it?

Chuck, any chance you could record an audio clip of the pedal with your mods?

I built this and I don’t think it kills the signal either fully CCW or CW. My guess is that the dual pot is shorting. I had to stick a thick piece of cardboard to insulate it from the board, I would try that first. Dual pots are frequently part of troubleshooting threads. While you’re at it, I...