Search results

I use mine to check my pickups after I wind them. When I tested them against a known value of my DiMarzio and my Seymour Duncan it was correct. When I first got into winding pickups I was told from other members of a pickup winding forum that I needed a LCR. I have this person PCB and haven't...

I have this one https://www.amazon.com/dp/B013IFC6N2/ref=cm_sw_r_tw_dp_x_J-XiFbJC37MBR

I own one and the "neutral" on the ac outlet really isn't neutral just a hole. Ooops yours don't have the neutral hole on the AC outlet. I use at a psu when I troubleshot my pedals.

I have 3 DMM.. my Fluke 189, a Craftsman which is about 25 years old, and a LCR/DMM Made over seas. I will always purchase a Fluke just because I've been using them since the 80s and they have always been reliable. My Fluke if for work, my craftsman is for home, and my LCR/DMM is for when I...

I got them ebay about 8 years ago and they were in my original Fuzz Face Clone. I don't remember leakage measurements.

Nope.

Thanks. I'm probably going to just try NPN..

anyone?

For ground(earth) I'm going solder all ground to a washer of the input jack.. The LED I was thinking just putting it on SW and GND on the Switch lugs that protrude through the breakout board.

Yes I did.

https://www.taydakits.com/instructions/fuzz-face/pages/enclosure-and-wiring--21 This was one of my first pedals I built, but robbed it of parts at one time. Now I'm putting it back together. My question is how do I wire this using a PCB 3PDT breakout board and I'm using Ge (PNP). Minus the...

I went to check the biasing of my Twin Face with the trim pot fully CCW I can only get it to -5.35v. Bad trim pot?

That graphic is bad ass!

Don't have a 50k... was going to take one of my 250k and use a resistor, but the pots should be here by Thursday.

Well I started mine and about 90% with it. .I didn't double check my order and didn't notice I only ordered 1 A100K pot. Ordered one today and hopefully I will have it by Thursday.

Strategically placed radial cap. :)

Nice!

I use gravity as well and use these https://www.harborfreight.com/test-probe-set-5-pc-61872.html just heat up the solder put the pick and turn it a little, the solder doesn't bond with the pick.

Maybe a piece of plexiglass. I received my PCB yesterday, but will start to populate it this weekend.

Like these two....