Search results

I would start by increasing c3. That’s what I do on tube screamers.

I think you need to solder the switch here looks like there is nothing on the middle and left legs.

The voltage on ic3 pin 1 should go up and down depending on where the rate knob is. Does yours fluctuate? Make sure the switch isn’t in the middle position when you try

Can you tell me what is going on here? This pot seems to have 4 connections?

I would love to know too. I made this on a breadboard and it sounds great. Would love to have this in a wah enclosure.

I didn’t know you could update the firmware. I’ll have to look into that

Thanks. Does it do germanium transistors too? Mine also won’t do that.

Where did you buy this tester? I bought a very similar one but it will not read jfets

When did you submit the order? I would message tayda to cancel the order if it hasn’t started. They are pretty good about doing that

I think you may have the wrong value in r28. It should be 330k (orange, orange, black, orange brown) but your colours look different from to me. Can you check what you gave there?

Thanks so much!

Hi. Are you able to share some information about how you made the custom pcb for the muzzle? I’m interested in doing the same myself since Pedal pcb is out.

If you are desperate you can use insulated jacks. These do not touch the enclosure

That means something is touching the enclosure when you put it in the box. The jacks are connected to ground so when you plug them in, whatever it touching the enclosure means s now connected to ground as well. Is anything touching a potentiometer maybe? Do you have those plastic covers on all...

Checking voltage can be a quick way to indenting where a pro might be. Also audio probing helps. Where are the places with correct volume and where does that stop? It can be a bad pot. If you have an ohm symbol on the multimeter l. Use that to measure resistance over pins 1 and 2. Should go in...

fantastic to hear. Glad you got it going. It’s always such a relief when you do.

Definitely. You have found the spot where the audio stops. Now just to explore the area to see why

Maybe swap ic1 and ic2 and see if you have the same problem. Could be a faulty op amp.

Every place you mentioned should have audio. The problem must be around ic2 because yes you shoukd have audio on pin 7 of ic2. The problem must be around here. I assume you have audio on pin6 ic2? I’d do the following Take it out of the box to make it easy. Check voltage on ic2. You want 9v...

This is right.