Search results

A single PT2399 delay may put you at 20mA+. That's really not so bad, though even on battery power.

The FV-1 will get you 1sec and will sound better than any PT2399 most likely. You can even program it to have PT2399 noise, if'n-u-want.

Great build!

For the rectifier diodes, you want something with a VF as close to 0.33v as possible. You can use BAT46 Schottky diodes as a sub which are 0.35v. Once you get into higher VF, the effect may not work correctly. I tried D9E recently which have a VF of 0.45v and they did not work at all! For the...

Yup, Q1 is your suspect. Audio probe the gate and source pins (gate for input, source for output).

It's not a dumb question. Ground is ground whether or not you are working with positive of negative DC voltage. In the case of an inverter, that 47uF cap is still a power decoupling cap but the + end is connected to ground rather than the - because in that case, ground is the higher voltage...

The j201 and 2n5457 can generally be be subbed for an MPF102 without issue.

I think the schematic is mostly correct EXCEPT Q6 on the schem (not my drawing) is shown as NPN and it is actually a JFET. And, it looks like my layout was erroneously done for NPN. So, what you need to do is: Using a 2n5457, flip the orientation as shown at Q6 on the PCB (so the transistor is...

I looked at this one recently while considering doing it as a regular project. I think there are a couple of errors. I'll check later today and get back to you.

Like benny said there is no switching problem that exclusively requires an SPST. For power on a tube pedal you can even do one better with an SPDT. Use a 1M resistor to ground on the extra lug to quickly drain the voltage off B+ on the tube pedal when powered down. However, there is one...

I'm your Huckleberry. But also, I still laugh about that. What fun we had.

Only Roman Gladiator style will satisfy my bloodlust!

Fight me.

Those jack nuts, though. It's got glamour.

Someone could make bank if they were to design a PP2+ style supply where every ground isolated tap can be selected b/w 9,15 OR 18v @ 100mA. It would solve a lot of issues (namely, abandoning the need for charge pumps). Is there one out there like that?

Proximity plate for a z*ex Wah Probe clone.

Even better.

I haven't built it but I am familiar with the circuit. Using a 25kA pot might give slightly more fine control in that area, but probably not as much as you want. So, instead, I would suggest limiting the range of the control like you are suggesting. Switch to a 10kA pot, and it should be wired...

Cool! -Edit - I keep mixing things up (deleted what I had here originally). Here's the actual correct info: For MN320x BBD chips, VGG should be set at 14/15 the value of the supply. So, if it's 9v, then Vgg is 8.4v. Supply limit is 9v on MN320x chips. So, 8.1v is correct for your 8.7v supply...

One extra thing: your supply voltage is on pin5 and you are reading 8.7v there, not 9. You want your Vgg voltage on pin4 to be about 0.6v lower than the supply for the MN3207. In that case, you may want to make R10 either 8k2 or 10k instead of 6k8. Or, just socket that resistor and use the value...