Search results

I have a 6 knob project coming up & I needed the aluminium on the top of a skinny Black Knob. With my Electric Hand Drill clamped sideways in the Vice with a 1/4'' stainless shaft & various grades of Sandpaper this was the end result. With a careful scalpel, the white pointer paint pops out in...

You need to post shots of the circuit & wiring as this is not built as designed going by the pots inline across the top!

You could say the same thing with toggle switches with Gain options and Clipping options, they Bang & Pop! All the boutique pedals??? do the same thing! Most people accept it or turn the pedal to bypass & switch then turn the pedal back on. I would have done that on the bottom side so it doesn't...

9 - 12v DC is ok, centre negative, At least 400ma!

Congrats!, See how much more space you can get between the 2 boards before it hits the Lid!!

I can't make out the Resistors clearly in the pictures but that is where I would start. That 4th band catches so many people out!!! Click on Bands for 5 Colours: https://resistor.cherryjourney.pt/

Do you get chorus now you have eliminated the touching of the PCB's

Here is the top PCB board with white components highlighted. There are a lot of areas that are prone to touch the bottom PCB with only a 3mm spacer as Feral pointed out!!! This barely fits in a 1590BBS with a 3mm spacer is a bad design. You may have to seperate the PCB boards and nip of all the...

Yep, what's 3K if the trimmer was linear!

Looks like an Original circuit!!!, does the YATS have 2 OpAmps & a Charge Pump???

Awesome Builds!

Cousin???, I don't think so!

A really Great Overdrive I have been told!

https://www.pedalpcb.com/product/pcb674/

Cool Build! What does the Yellow knob do? ;) This is coming in the mail to me, I have 2 that i built from Aion when they were normal looking PCB's way back with 9mm pots!

I have gone over this & can't find a fault, can you confirm that your electrolytics are the correct values, there are 2 100uf's that are different. The 1uf, 2 . 2uF & 10uf are the same size so check those. Can you confirm the 2 Transistors are correct? When you do a Continuity test, you can't...

9v Battery Powered1590A! This is an SMD project with tight clearances between components.: https://www.pedalpcb.com/product/pcb668/

Personally I use CRC CO Contact Cleaner, No brushing required: Just spray & watch it disappear & a 2nd squirt just in case any debris is still hangin' on:

It would pay to clean the back of the board, there is a lot of debris around that PT2399!

Something like this: