Search results

Hello, are you able to share the drill template? Thank you

Hi, To start with it sounds really good when I dime the level and fuzz. It achieves roughly unity volume. I tried A1M level pot as written in the schematics. But decided to swap it with A100k. Following what @Chuck D. Bones wrote here. I own an EQD cloven hoof and the unity volume is at 12 o'...

Done Thanks!

I found that the 100u cap I had used was rated 10v only, I swapped it out with a 50v rated one, This has tamed the noisy pot problem and now the pedal is quite usable. Thank you for your replies. Here's a picture of it sitting smugly on my board :)

So I found that the 100u cap I had used was rated 10v only, I swapped it out with a 50v rated one, This has tamed the noisy pot problem and now the pedal is quite usable. Thank you for your replies. I have to admit my noobishness as what I am doing is more like glorified Lego building, I don't...

@Betty Wont do you have the same problem as what pinoynoiseboy reports with the gain knob being noisy? I made a post earlier about this problem in my build.

The goop's built up after soldering and desoldering that damn pot 3 times. I will clean up and report back. I sub all those caps with 100n as suggested in manifesto's build report. I might try replacing the pot with A100 one, I think I neglected to mention that It works and sounds fantastic...

Hi, The drive knob sounds like loud scratchy pot when I turn it. I've tried cleaning the pot with deoxit. Also replaced the pot twice. I've used the alpha branded ones and now the tayda one. The problem persists. I checked all soldered points and they look fine to me. I'm out of ideas. I...

tyvm @fig I am still learning how to read the circuit diagrams. I have to admit I didn't try looking there.

Hi I am working on a trojan horse build. I can't find a SLA switch though. Search turns up network switches - which I am assuming is not what I need here. I have DPDT on off on and DPDT on on on switches on hand. Will any of these work? Thank you