Search results

Two questions really. I've been jamming basic relay bypass boards into my pedals recently, and two I'd like to update, the lowtide obviously has not a lot of space to put it in, and the duocast has a channel switch - can I use the basic relay dpdt switch? or one of the intelligent relay modules...

This is potentially more of a sanity check than anything else. I'm building a muzzle, and I'm using a basic relay, as well as a simple jfet buffer for what I hope is the input. I heard this circuit likes a buffered input so I figured internally would be good. It's just occurred to me that the...

I um, wanna build a clean boost. I want it to be properly clean, no overdrive. I run a Squier tele with stock pickups. I don't really mind the pickups, they sound fine to me, I don't know anything about guitar, but I like building pedals. The part of my setup that concerns me, I use a HX...

I built a cobalt drive. The 250K dual pot was purchased from pedalpcb, and has some weird behavior. I'm aware of the J201 biasing issue with this pedal, I'm hoping for some other info before i get to that. So far, the build is stock. I had played around with R6 for biasing, but have put it back...

I bought a couple of PCBs. Cobalt Desolate fuzz Chop shop (v3?) Son of Ben Cobalt will need adaptors and that's fine, I do have some, I know the others have pads for direct soldering, which I would prefer. My reading suggests not all smd 201s are equal, and I have ordered the actual 201s from...

Hey all, I'm hoping to finish off a notakliche feeding into an uberdrive this weekend, and just have a couple of questions. I'm looking to use bat41 for the main diodes at the bottom of the PCB - I can see the PCB is labeled with a stripe for what I assume is the cathode - although I also read...

I built the delegate boneyard. I have finally got a looper pedal so I could record something and then tinker with the pedal...all controls except Ratio seem to be working. I've tried lots of combinations of the pots and playing but no difference where the Ratio is set. Now, I'm by no means a...

Requesting confirmation of Circulator- Is it just 6 knob type using the correct drill diameters for the switches and pots?

Thought I'd make a thread for my builds, there's nothing that spectacular, maybe this is more just a thread for me to refer back to what I've done for myself. I get all my shit from tayda cuz im a cheapskate. Right to left PPCB Boneyard Delegate PPCB Uberdrive PPCB Sherwood PCBguitarmania Elk...

Hey guys, simple question, I'm pretty new and don't have any experience reading schematics, so a pedalpcb build that's basically solder by numbers works great. I have a spare 18v port on my power supply I'd like to use for the delegate boneyard if I could omit the chargepump... would I need to...