Search results

  1. T

    Electrovibe LDR 9203 versus GL5537-1

    I have the GL5527-1, but it calls for an LDR 7530, 7532, 9203, or similar. It seems if I read the data sheet (If I understand) The 5527 is less sensitive. Im not quite sure how to compare them, any thoughts? GL5527 datasheet: https://datasheetspdf.com/pdf/756864/CdS/GL5537-1/1 9203 datasheet...
  2. T

    lifted pads need help finishing wiring

    Well, to finish a long arduous project called fuck it up some more I lifted the pads on the Hydra for the LED and for the 4k7 R13 resistor to the LED. I have bridged the anode of the Diode D1 to the anode of the LED. I haven't done anything with the Cathode yet. Trying to figure where to tie...
  3. T

    Hydra FV-1 pin 1 and 28 voltage

    Question. What should the voltage be going in pin 1 and coming out pin 28 be on the FV-1 chip? I'm getting 1.7ish https://docs.pedalpcb.com/project/Schematic-Hydra.jpg
  4. T

    what temp should my soldering iron be to not melt the board

    I have melted the LED pad on two pedals trying to suck out solder. I have never had this problem before. any suggestions? Literally melted the hole shut.
  5. T

    Pulled pad Hydra

    Lifted pad on the 4k7 resister for the LED. anyway I can bridge this? Schema. https://docs.pedalpcb.com/project/Schematic-Hydra.jpg
  6. T

    SOLVED Hydra delay pedal doesn't fit template

    I've built the hydra delay and drilled the template. I have also purchased the face plate and the PCB doesn't fit. The On-On switches are off the face plate by a 1/16 of an inch. Has anyone ever mentioned this problem before? I used 16mm right angle through hole pots, but the only way this...
Back
Top