Search results

Thanks! I figured it was from the enclosure. I put some electrical tape on both sides and in the hole and it works just fine. I’m going to source a couple nylon washers instead of using a plastic jack.

I don’t have the sleeve connected. I used a neutrik switch tip jack. Is this jack from tayda insulated? https://www.taydaelectronics.com/6-35mm-1-4-stereo-phone-jack.html

I pulled the key input from the enclosure and sure enough everything works key input no longer causing noise when I disengage pedal. So for some reason when I remove the ground from the key input the noise goes away.

Everything appears to be working on my muzzle except when I turn the pedal off I get a lot of noise( I’m not being funny I know this is a noise gate) it’s very noisy. When I disconnect the key input the noise goes away. When the pedal is engaged it works as it should and everything is dead quiet.

I got it working by tightening the nut back and forth on the pot. It is working as it should and sounds great. I will reflow the pot when I get a chance just to make sure.

I can’t see anything that would be making contact but when everything is out of the enclosure and I grab the bite pot the noise comes back.

I was going too but I wanted to test the circuit first. I will try it when I get home.

I built the wonder drive and tested it and all was good. When I put it in the enclosure I get a lot of noise. When I remove the jacks from the enclosure and leave them hanging the noise goes away.