Search results

So that fact that I’m getting voltage to the first two Diodes but no then next 4 Isn’t any issue?? im getting good voltage through all of those foot switch pads??

What’s up everyone just finishing up my 2nd attempt at the paragon. 1st was a mess. Half the pedal is working. The Left / Boost / Yellow side is working perfectly. The Right / Overdrive / Red side is not. LED is working on that side. When that side is engaged all signal is lost essential...

I'll double check the in out wires are going to the correct lugs. I don't have a coupler unfortunately. the DC jack wires are soldered on the underside, but I can add a little more solder on the top side.

I can assure you that everything is soldered. That one is on the underside

over to the university of YouTube it is then!

Appreciate the help, I poured a lot of time and money into this one so am eager to get it rocking

The only noise is I can get out of it is Loud buzzing when I touch my finger to the longest pole of the output jack or the 9 pin connector.

yes, but it will be my first time using it

I was just trying to accurately follow the Schematic on the website. I flipped over the two ground wires on the input jack I also just changed the two wires on the output. the problem still persists on both 9v power and battery. thanks for the assist

thanks fuzzonaut thats golden

Hi all, After spending what seemed like an eternity to collect all of the components for the Paragon build finished up assembly this morning. Frustratingly, when I went to plug in it seems I've created a dead box. No LED's when foot-switches are triggered. No sound either. Sound of silence...

Hi All. Just wanted to get some advice from those on this forum who are far wiser than I am. I'd like to put the sunflower fuzz and the muffin fuzz in one 1590BB enclosure. I'd like to be able to run them of the same 9v Source and have them on separate foot switches but be able to stack them...