Search results

Indeed. However the loop on the EUNA shuts the buffer off and activates whatever pedal is in it.

Honestly I have no idea what’s changed. The bias knob is fully counter clockwise. Taking the fuzz out of the 29 Pedals EUNA effects loop seemed to wake it up. I swapped the original q1 308B (I think, GT308b?) back in, and it’s great now. I don’t think the other transistor was the issue though...

I’ll reflow and report back. I believe the trim pots are the right values, unless I managed to mix them up. I can double check that as well. I did remove the fuzz from a pedal efx loop in was in, and some volume and fuzz returned. But the fuzz is super farty sounding…

I did not. I have a breadboard set up to do this but iM still new enough at all of this that I need a visual vs. the schematic. I know it’s a simple set up but alas…

Just built this last night. Q1 measured 79, Q2 I think is 150 or so? Maybe a bit less. Biased Q2 to -4.5v, and the clean bias trim is all the way down. I hardly get any fuzz, I have to dime both volume and fuzz, and even then it’s pathetic. Built to specs, the only thing I did different was...

I sorted it out, by removing the switch pcb and just wiring it manually. I’m clearly not understanding vital element when using a switch PCB. If I use the LED pads on the switch PCB, how do I power the LED? There is an extra 9v/ ground pad, I figured I would just run 9v and ground straight to...

I am using a Love my Switches switch PCB, and a prewired LED w/ resistor. My last pedal, I ran a wire from the dc jack 9v and ground to the respective solder points on the switch PCB, and everything works. My most recent build, a Bellum MK ii, when I do the same thing, the pedal doesnt work...

Just looking, can anyone tell me what’s missing or going wrong? I’ve followed instructions (presided w/CLR, red goes to red, black goes to black) and well as images I’ve seen online and everything seems to check out. Pedal works, no LED. I know it works because when I jump it to 9v and ground...

Thanks!

I have two trem pedals that I break out for specific needs. 1-Dreadbox treminator. I like this because it has a feature where you can delay the trem effect to come in right away and taper off or have the effect slowly (or quickly) build. i do not like that fact that it has a CMOS buffer, and...

Hi All, Im currently building a Percolation Station. The schematic calls for a 2N404A in Q1 and 2N3565 in Q2. I have these components ( I have a 2N404 non A). In one of the reviews, someone mentioned Albini mods and a BC108 transistor. The place I got the others had these so I grabbed a few...