Search results

https://lovemyswitches.com/no-indicator-aluminum-knob-the-void-1-4-smooth-shaft-20mm/

Nice! Great job, and love the bat switches with covers. Interesting comment about enclosure colors because that’s something I can relate to. I’ve always thought yellow OD, red distortion, green phase, light blue chorus, white delay, black vibe, violet reverb, silver or gold for fuzz. I’ve never...

Thank you @Robert

Hi @Robert Working on my next order and wanted to ask about the transistors and ICs for the new Quarry Fuzz. When you have a chance, can you let me know what these are for parts ordering? Thanks much!

I like it. Compared to a standard type muff, it seems to clip a bit more sputtier, and to my ears that’s the difference with this one. This is the first build where I’ve used A1015s. Surprisingly I had some left over from an electronic components starter box from Amazon I picked up a few years...

Thanks @Robert!

That was the issue - thanks much! 👍

Working on a build of the new offering Cast Iron Fuzz (Lollar Fuzz). Works in bypass but when effect engaged, the fuzz sounds great but is barely audible. Using A1015 transistors per the board. @Robert, when you have a chance, can you provide build docs, most notably the board components...

I lower the table slightly, place a 2” thick board on the table, and readjust the height so the bottom of the bit is just above the enclosure top. For input/output jacks, power jacks, expression pedal jacks, etc I lower the table down all the way and use a disposable terry towel (blue roll towel...

When Tayda stopped offering pre-drilled enclosures, I thought I was done pedal building because at that time I felt drilling enclosures was beyond my ability. Then, a family member gifted me a table top drill press and it’s been smooth sailing since. i had to give it a little time to get used...

I put this 2-in-1 together about 2 weeks ago using Aion Refractor and PPCB ADHD. Sloppy off board wiring is pretty cringy, but works and sounds great.

Would appreciate any help with wiring for the channel select side with 5 connections to the 3PDT footswitch. Thanks much!

Thanks for your response and sorry for the miscommunication. I meant to point out in the OP that the BC549Cs were correctly installed by reversing them so someone wouldn’t point that out as a possible problem. In terms of polarity, can someone explain the 3 eyelets for the cap through holes? I...

I’m building the Emanating Fist Dope Priest where the BC549Cs are installed backwards. Only passes signal in bypass. Thanks for any help

During build, I did notice that there isn’t R24, or C14 or C15. No problem there. Just assume those values aren’t present in the circuit. From the Muffin schematic, D100 is 1N5817, and I assume CLR corresponds with RLED and is a 4.7K resistor as typical. What is C100? I’m guessing 100uf...

Thanks much!

Double muffin arrived today but no components silkscreened on the board. Same with Oroideous Drive. When you have a chance, please post BOMs. Have a great holiday and thanks for all you do! New projects lately have been awesome 👍

Seasons Greetings! Thinking about the 410 Fuzz as a future build. For parts ordering purposes, what transistors go in Q1 & Q2? Thank you as always!

Solved - bad connection on 12k & 1k tented resistors to make value indicated 13k on R39. Replaced tented resistors with 12k resistor and resolved the issue.

Page 7: https://aionfx.com/app/files/docs/andromeda_deluxe_documentation.pdf