Search results

Thanks. I’ll check them out.

Hey all, I’m wondering if anyone has had luck sourcing the HT8950 chip used in the Roboto? I’ve searched all usual sites (ie, Tayda, small bear, Moser....) Any thoughts?

Gee wizz, so I managed to get the switches out. That was stupid. Flipped ‘em a solid 90 degrees and voila! It worked, sort of. No bypass signal now. No LED either. Side note: I did originally have the same issue as Jones where, only the right Led was illuminated when grounded. Welp I’d say...

Thanks for the quick reply. I’ll attempt removal but I have more switches if necessary. If I needed to wire the switches in (eliminating the breakout board) would I follow Pedal PCB standards for other switching? Re: the board is not labelled and the jack jumpers are run through the main PCB...

I remove the LED when I thought the leads might have shorted on the LED holder but the problem still exists.

I’m new to building and have had success in the couple builds I’ve done so far. I’ve posted here hoping someone with troubleshooting experience may help as it’s beyond my abilities at this point. I’ve just finished a Paragon (new version) and have no switch function. There is anywhere from...