Search results

Hey Hive Mind, first FV-1 build done and i am only getting dry signal when effect is active. -Pots all seem to be working, can probe and get signal (obviously blend pot has no wet signal though) -FV-1 has signal at Pin one, nowhere else. No probable audio at EEPROM pins Any other thoughts on...

I put a CA3130EZ in my Muroidea build and its noisy. However, i am on the fence with what should be considered acceptable noise since I don't have an original RATto A/B with. Any thoughts on switching to OP07 or other?

Preface: Noob here. Troubleshooting the Mini-Muffin Fuzz. Passing signal, though only slightly distorted, not fuzz. After C1, signal drops significantly. Virtually no prob-able audio at inputs of IC (pin 2 or 3). Output of IC at Pin1 is plenty loud, not distorted. Signal at C2 (post diodes...

Just finished up the Captain Bit build and testing on the auditorium board. I have signal passing, but its LOW level and only distorted. Seems that the pots have zero effect on the output signal. Looked over my solder joints, components, etc. and nothing standing out. About to get the probe out...

I just went to start PCB159 and the resistor thru hole spacing is considerably smaller than other PedalPCBs I have worked on. I can not get my 1/4w resistors to seat properly in their respective positions. Any suggestions? Thanks in advance.

I would love to build one of these