Search results

Thanks! Jason I was dubious to start. especially having only built one amp before which was pretty much a paint by numbers (not that its a bad thing, but Trinity docs are absolutely fantastic!) If this is your first you might want to think again? This doesn't come with much but the layout...

Hey, it’s under switches. S4 but doesn’t give you any types. They are pretty standard. I used one of these. https://www.amplifiedparts.com/products/switch-rotary-1-pole-3-position-0 Hope this helps and good luck with it. Drop me a line if you need any info.

Top quality work again @MichaelW I'm just in the process of finishing my write of of my Strat that you forced me into haha ;-)

Good to know!

Hi Mick See attached and let me know how you get on. If you cant use it just PM me your email. Phil

Of cause. See attached and let me know how you get on. If you want the Illustrator one then drop me a PM with your email and I can send it onto you. I cant seem to attach it here.

I used the drill template from Aion and added it to illustrator for my UV print. I then used used a printed copy of the drill template and did it off school with my drill press. Seemed to work out perfectly! There is a lot of holes to drill though!!

I finally got around to finishing mine. Dan graciously did the artwork for me ans I love his original ones. And I have to say it looks amazing. It was my first time soldering SMD parts so I was worried about that and having to maybe troubleshoot! But the soldering went easier than my eyesight...

Looks great!

Fantastic. Thanks for that. Did you print it yourself?

On a completely different note, which stand is that?

Thanks Christian. Your help is much appreciated!!

I have to admit I do love a Phaser! So jumped at the chance to build this Aion board. Although it’s a big PCB the build it pretty straightforward especially considering some of the large Aion builds! You just have to be careful with the drilling. Their drill guide works perfectly and mine...

Go for it! You won’t regret it.

Watching @Guardians of the analog @blackhatboojum build several absolutely stunning @dan.schumaker boards I decided I would love to try one myself. Chris’s rendition of the Chris Isaak track was so gorgeous this pedal doesn’t disappoint. I tried my best to honor these builders with a neat and...

Great work! Looks fantastic. That’s some dead straight wiring. Makes me want to re-do some of mine 🤣🤦‍♂️

It’s 2 going to the pilot from the transformer. Then 2 going to AC1 and AC 2 on the board. Then 2 going to V5 (pin 9 and pin 4/5) They are all jumpers to the other pre amp valves. Then down to the power amp too. So you would just connect V3,4,5 together. And then the DC to V1/2.

I did. That’s the Faux ground I needed. Kept it all neat. And no need for another bit of strip. I have also seen them done near the IEC too. I ran a wire from the pre amp tubes down to the power tubes. I think you could do both though. One pair to the pre and one pair to the power. I took a...

Check out some pics from http://www.c3amps.com/ In the build section. There is a little description on some of them too. Helped me a lot.

Different pic.