Search results

Thanks, but been making holes in metal for a very long time. I'm just lazy and should have them drilled while I had it printed.

I did get it printed with thanks from dmnCrawler tutorials. This is for the Lot Lizard which I will eventually start to build. I haven't started the buffer I got a few months back, by a few months I mean last August. Hopefully my holes line up.

Yes.

It all depends, if you like Fords then yes this is a Ford advert :) if you don't like Fords then its just a truck by a turboprop. :ROFLMAO:

I have a Longer 4KPro, it printed great then about six months ago it went to the sh**ter. I haven't had a good print since. I've been troubleshooting when I feel like it. Might get another hotend for it.

Adjust the trim pot.. I finished mine a few weeks back and did the same thing. I adjusted the trim pot until I found the sweet spot. Go in small increments. Also I think one stage is subtle over the other.

Get one of these https://www.amazon.com/1HZ-500KHZ-Functional-Generator-Seesii-Frequency/dp/B08NSR5GYR/ref=sr_1_3?crid=WTOTKLTK0BVA&keywords=Signal+Generator&qid=1664483189&qu=eyJxc2MiOiI1LjMyIiwicXNhIjoiNS4xMCIsInFzcCI6IjQuNTUifQ%3D%3D&sprefix=signal+generator%2Caps%2C110&sr=8-3

Check out Donners looper.

I purchased a UNi-T UTG962E for around 100.00 a few years back.

My favorite by far has been Kliche... It's the one that I have used the most and always stacked with others.

Yes, I have the SMD pad. I will clean it up and test it again. I guess the 2N3904 is too low of a gain for this pedal?

My LCR-T4 is fubar'd 2N2222A with the meter hfe = 431, using the bread board = 270 2N3904 with meter hfe = 430, bread board = 127 BC337 meter = 430 - bread board 244 S8050 meter = 420 - bread board 160

LCR-T4 Mega328 ... My DMM is being a pain and will have to get my fluke from work. For some reason it's not reading µA and the mA is sporadic. I'm using a 470K on the base with a 9v input. Going from E to GND and then putting 9v into the C to GND and not getting a good reading either...

My DMM and Transistor tester is wrong as everyone of my NPNs are 280+ hFe.. My 2N2222A are all 480+ hfe. I got some from Tayada, Mouser, Newark, and Amazon.

Mixing NPN will it make a huge difference or should they all be the same? For example 2N3904 and two 2N222A.

Thanks, but that still shows the rotary switch. My version didn't have the rotary switch and pretty sure the silkscreen Diodes were incorrect.

I decided to troubleshoot why I'm not getting any changes from toggle switch in the middle position and the toggle being in the up position.

Some kind of hornets nest I snapped while I was in Cancun. If you can't tell I zoomed in.. wasn't going near that thing. I didn't want to get impregnated by an Xenomorph. :)

I get my magnet wire for my pickups and my hook-up wire from Remington Industries