Hey guys I’m working on a concept to build a bypass looper with stacked jacks probably like 6 loops that will house an arduino nano and have a midi in port that will control all the loops. Kinda based off the Morningstar ML5. I’m not going to do any learn functions or anything just a controlled looper. I’m also still planning to include switches to manually activate each loop.
Likely going to try and out this in a 1032L enclosure but might go smaller if possible. This could be great underneath a board if you were fine controlling all through midi. Mine is going to go right on top where my old TB looper goes.
What do you guys think? The nano has enough pins if I use multiplexers for the leds, switches and relays. I’m working on the schematic and pcb now.
Likely going to try and out this in a 1032L enclosure but might go smaller if possible. This could be great underneath a board if you were fine controlling all through midi. Mine is going to go right on top where my old TB looper goes.
What do you guys think? The nano has enough pins if I use multiplexers for the leds, switches and relays. I’m working on the schematic and pcb now.