REQUEST Combining MGMM, Tyrian, and 6 Band EQ onto a single 1590DD Drill Template

D

drakonicfury

New member
I dont have a way to reliably measure as I dont own calipers and dont have the boards yet. Could someone help me combine these into a single drill template? Im planning on having the OD, then the Tyrian, then the EQ all integrated into a single unit.
 
Im not saying I “will” do it but i may have a day where I am bored enough and I “might” look at it. No promises. I assume you are talking about the 6 pot eq not the sliding pot version? I can go ahead and give you a hard no if the sliding pot is what you want. A “might” is better than a no though. I generally don't do a lot of combos but its got to be easier than a deadendfx layout, lol.
 
Audandash said:
Im not saying I “will” do it but i may have a day where I am bored enough and I “might” look at it. No promises. I assume you are talking about the 6 pot eq not the sliding pot version? I can go ahead and give you a hard no if the sliding pot is what you want. A “might” is better than a no though. I generally don't do a lot of combos but its got to be easier than a deadendfx layout, lol.
Click to expand...
Yeah.. its the slide pot one. I dont blame you for not wanting to do that, I just thought I'd ask on here before I go ahead and figure it out on my own.
 
Fortunately there’s prior art to draw from. The Mean Green Metal Machine actually has an official drill template on the product page, so there’s the measurements for that one. There’s a drill template for the EQ one in the forum. And then for the Tyrian, you could use the 6 knob template, and choose to make the switch hole a little smaller.

A combination of research, planning and arithmetic will get you there.

Also, inexpensive digital calipers can be acquired for $10-12, the cost of a PCB. I use a budget one and it works fine.
 
You must log in or register to reply here.
Back
Top