Connected voltage in reverse. Oops

[Tarantpres]

Was testing my leprechaun pedal and didn’t notice right away that I connected the voltage in reverse. Dumb mistake since everything was fine. There is no audio, only the dry signal that comes in, but even without power you can hear the dry signal if I connect my synth. The led lights up. That’s about it.

where should I start?

 

[Robert]

Reverse voltage shouldn't have damaged anything if the 1N5817 polarity protection diode was installed.

If you're hearing dry signal with no power applied and the pedal switched on there might be a wiring problem.

 

[Tarantpres]

Reverse voltage shouldn't have damaged anything if the 1N5817 polarity protection diode was installed.

If you're hearing dry signal with no power applied and the pedal switched on there might be a wiring problem.

I see.. I’m looking at the connections but they seem to be correct. I attached the picture to see if you can see the issue. The tip of the jack is connected to the switch, is this correct?