Matopotato
Active member
I got an inductor as part of a kit. 8 legs. 2 of them have thin copper wire reaching them, the others seem to not respond to my DMM, but the encircled ones show 730mH (ish) between them.
Which pads on the board should I connect and solder them to?
And should any other legs be soldered to any other pads?
I read somewhere that "put the legs in the holes but do not solder them", which puzzles me.
Thanks in advance.
Which pads on the board should I connect and solder them to?
And should any other legs be soldered to any other pads?
I read somewhere that "put the legs in the holes but do not solder them", which puzzles me.
Thanks in advance.