Does any one have a pic of the Tayda pre drilled 125b with the MXR type knobs on?

[LordZavrid]

I'm going to build a Wrectifier and would like to know if there's enough space for the MXR style knobs that Tayda sell on the 125b pre-drilled enclosures? The knobs are 20mm diameter but the distance between the centers of the holes is apparently just 20.3mm.

I'd like to know if this is doable or if it will it just look silly

The case: https://www.taydaelectronics.com/black-a-pedalpcb-125b-bare-drilled-enclosure-type-5-1.html

The knobs: https://www.taydaelectronics.com/hardware/knobs/mxr-style-fluted-blue-knob.html

 

[Grubb]

I haven't seen it in real life, but I've designed all my pedals in Illustrator and I can tell you it looks way too tight with anything past about 16mm on 20.3mm centres. I'm looking at 15mm knobs on my Complex build for that reason.

Edit: would these work for you? https://lovemyswitches.com/mini-mxr-style-knob-no-skirt-15mm-od/

 

[cdwillis]

Sorry for the poor picture quality, but here's my Hoof clone in 125b with Tayda's MXR style knobs:

https://imgur.com/a/LLvBapT

I don't think you could fit a third knob of that style in between even with the holes spaced out.

 

[spi]

I think for the 5 knob, you'll need skinnier knobs.
I have one I'm about to build, and I chose the Davies 1900H for this reason (they are 12.7 mm)

I have fit those MXR mini knobs that @Grubb refers to on a 3-knob across build, and they fit fine.

 

[SYLV9ST9R]

I think for the 5 knob, you'll need skinnier knobs.
I have one I'm about to build, and I chose the Davies 1900H for this reason (they are 12.7 mm)

I have fit those MXR mini knobs that @Grubb refers to on a 3-knob across build, and they fit fine.

Yep, I also find that 1611-style knobs work well, though a bit crowded.

 

[LordZavrid]

Thanks for the answers and suggestions, it's much appreciated. I've since found a pic of a 1590b with 3 of the 20mm MXRs in a row and it doesn't look good.

I'm tempted by 1611s or clear mini MXRs now but seem to change my mind hourly!

 

[Raymundo Stetzler]

Sorry for the poor picture quality, but here's my Hoof clone in 125b with Tayda's MXR style knobs:

https://imgur.com/a/LLvBapT

I don't think you could fit a third knob of that style in between even with the holes spaced out.

Do you have any form of an item/sku list for the parts used in the Hoof clone?
I'm very green and do not know how to select my components

 

[BurntFingers]

tayda 3 knob w/ black MXR knobs.

 

[moonlightpedalbuilds]

not pre-drilled from tayda. What you can do is make the hole larger on the two outer knobs so you can move it a millimeter away from the center knob to make mxr type knobs(or boss type) fit.