Drill Specs for Paragon Mini

[Big Monk]

I'm looking to put together a Paragon Mini and want to use a Tayda Enclosure.

The control holes look to be the same as the 6 pot pre-drilled enclosure. I imagine by using the 6 hole pre-drilled as a reference, I can suss out the holes for the switches and LEDs.

Just to sidestep that if possible, does anyone have a drill template for this?

 

[Big Monk]

 

[benny_profane]

Double check your jacks at the top (unless you're using two different types of jacks with different diameters).

 

[Big Monk]

Double check your jacks at the top (unless you're using two different types of jacks with different diameters).

I am. I use the larger plastic, Cliff style jacks for output. Thank you though!

 

[Big Monk]

Just a tip:

if you have a graphic design software like Corel Draw, you can load the drill plans from the build docs and measure all the holes off the center of whatever face you are working on.

Since Taysa wants everything off the center, you then use those values to develop any and all hole patterns for the drill plan you need.