Electrovibe Mini parts question

[Kinski]

So im sourcing all the parts needed for the Electrovibe mini. I'm assuming its the same parts except only one C100k dual pot need, since it only has 1 speed pot.

The BOM also lists a 500R trimpot. Is this correct? Not 500k?

Also, a drip template (and build doc) would be much appreciated!

 

[Robert]

500R is correct.

The electrolytic capacitors need to be 7mm height low-profile caps.

You'll also need some male and female pin headers (2.54mm spacing) to connect everything together.

2 x 3-pin Male
2 x 3-pin Female
1 x 6-pin Male

 

[Kinski]

Thanks for the response. Where are you sourcing the 7mm height caps?

 

[Kinski]

Or would tantalum caps work?

 

[Kinski]

Found all the 7mm tall caps on Mouser. Picked up a 7371 lamp there as well.

 

[Preverb]

I am torn about this one. I don't use vibe much and this looks like it is going to be pretty hard. And yet there is a current black friday sale!