aienco
Member
Hello everyone. This is more a question on whether this is normal or not. I have just build this simulator. All works perfectly however when in CLEAN MODE, and I select Tweed mode, the volume halves. Doen't happen in any other mode.. Is this normal???
What I have done...
I found I had two resistors which were incorrect values. So fixed that.... Re flowed all joints... Replaced Tweed Mode Switch, Checked all values of capacitors.
Is there a particular resistor/capacitor value that I can change to bring this tweed volume up in Clean mode?
Guidance would be appreciated.
What I have done...
I found I had two resistors which were incorrect values. So fixed that.... Re flowed all joints... Replaced Tweed Mode Switch, Checked all values of capacitors.
Is there a particular resistor/capacitor value that I can change to bring this tweed volume up in Clean mode?
Guidance would be appreciated.